decina PREZZO PRSSANG900C User manual

PREZZO SEMI-FRAMELESS ANGLE SHOWER SCREEN INSTALLATION MANUAL
Thank you for purchasing a Decina Prezzo Shower Screen.
This manual provides the correct steps & care advice for a safe & long lasting installation.
Manufactured from clear 6mm toughened safety glass with fully framed chrome door and frameless return panels, the Prezzo’s
generous, angled internal design maximizes space in the bathroom. The pivot door opens easily with an interior/exterior,
square stainless steel handle. Install on tiled floor and walls or combine with a two-sided acrylic shower wall
and an acrylic angled shower base [shower system].
THIS PRODUCT MUST BE INSTALLED BY A QUALIFIED TRADESMAN
PRSSANG900C 900 x 900 x 2000 (mm)
READ CAREFULLY
PRIOR TO COMMENCING
INSTALLATION
!Unpack & check the item is correct & not damaged. If there are any visible defects do not
proceed with the installation & contact the place of purchase immediately. ANY CLAIMS FOR
DAMAGE WILL NOT BE ACCEPTED AFTER INSTALLATION.
!Ensure there is a gasket between glass & metal components.
!Leave the plastic protectors on the glass corners for as long as possible & handle with care.
!In cold climates, warming the gaskets & seals with hot water or a hairdryer will assist with
the installation.
!A risk assessment should be completed prior to commencing the installation to ensure safe
practices are followed for the manual handling of the fragile glass.

SAFETY EQUIPMENT REQUIRED FOR INSTALLATION
TOOLS REQUIRED FOR INSTALLATION
∙ Use the correct drill bit for the material being drilled. The 6mm drill bit is required for anchor
fixing and the 3mm drill bit is required for screwing directly into the wall studs.
∙ As with all toughened safety glass, take care while handling and wear safety glasses and
gloves for protection.
Protective Clothing Foot Protection Eye Protection Hand Protection
Silicone Sealant
Pencil
Utility Knife
Drill
Phillips Screwdriver
6mm (1/4”) Drill Bit
Level
Tape Measure
3mm (1/8”) Drill Bit
Rubber Mallet
Cutting Pliers
ENSURE YOU HAVE ALL TOOLS FOR THE COMPLETE INSTALLATION BEFORE COMMENCING.

PARTS LIST OF DOOR
NO. QTY DESCRIPTION
1 1 Wall channel
2 1 Squeeze gasket
3 1 Fixed panel
410 Wall anchor
5 1 Side gasket
610 Screw ST4 x 40
710 Washer
8 2 Rail
9 2 Pivot cap
10 7Screw cap
11 4Screw ST4 x 16
NO. QTY DESCRIPTION
12 1Glass door
13 2Wall channel cap
14 1Wall channel
15 3Screw ST4 x 10
16 1Magnet channel
17 1Magnet gasket
18 1Handle
19 2Squeeze gasket
20 1Bottom gasket
21 1Bottom gasket
22 1Gasket tool
page 5 of 15
BRISTOL
SHOWER SCREENS
-3-
Parts List of Door
11
22
33
34
55
66
77
88
9
9
1010
11
12
13
14
15
16
17
18
19
20
21
22
ST4X40
ST4X16
ST4X10
1
2
1
1
1
3
1
2
13
14
15
16
17
18
19
20
21
1
2
3
4
5
6
7
8
9
10
11
1
2
7
4
1
1
10
1
10
10
2
12 1
22
1
1
Squeeze gasket
Wall channel
Fixed panel
Wall anchor
Side gasket
Screw ST4X40
Washer
Rail
Pivot cap
Screw ST4X16
Screw cap
Glass door
Wall channel cap
Wall channel
Screw ST4X10
Magnet channel
Magnet gasket
Handle
Bottom gasket
Gasket tool
Squeeze gasket
Bottom gasket
NOQty Description NOQty Description

PARTS LIST FOR RETURN PANELS
NO. QTY DESCRIPTION
1 2 Wall channel cap
2 2 Wall channel
3A 1Channel cap L
3B 1Channel cap R
4 2 Squeeze gasket
510 Screw ST4 x 10
6 2 Fixed panel
7 1 Allan key 2.5mm
page 6 of 15
BRISTOL
SHOWER SCREENS
Parts List of Return Panels
-4-
1
3A
3B
4
5
6
2
2
2
1
1
2
10
2
NOQty Description
1
2
3A
4
5
6
Wall channel cap
Wall channel
Channel cap L
Channel cap R
Squeeze gasket
Screw ST4 x 10
Fixed panel
3B
Allan key 2.5mm
71
7

DETERMINING WALL CHANNEL LOCATION
page 7 of 15
BRISTOL
SHOWER SCREENS
-5-
When commencing step 1 on the following page, please refer to this drawing and the tabulated
dimensions for your size of system to assist in the correct location of the wall channels.
- Locate the size of your shower screen in column 1 and use the value for X and Y on the same line
to find the distance from the shower wall to the outside edge of the wall channels. If a shower base is
fitted, do not measure from the edge of the shower base to determine the position of the wall channel.
- If your wall and shower base are not at right angles the glass will not push fully into the wall channel
at the top or bottom. This misalignment is acceptable if not exceeding 15mm, however the overall
shower size will then increase by the amount of this misalignment.
- If the screen footprint does not turn out square while the aluminium braces are being installed (step
3), the glass can be pulled out from the full depth of the channel by up to 15mm to assist in squaring.
Determining Wall Channel Location
Size
1000
859-871
X
900
959-971
Size
1000
859-871
Y
900
959-971
Y
X
When commencing step 1 on the following page, please refer to this drawing and the tabulated dimensions to assist in
the correct location of the wall channels.
• Use the value for X and Y on the same line to find the distance from the shower wall to the outside edge of the
wall channels. If a shower base is fitted, do not measure from the edge of the shower base to determine the
position of the wall channel.
• If your wall and shower base are not at right angles the glass will not push fully into the wall channel at the top
or bottom. This misalignment is acceptable if not exceeding 15mm, however the overall shower size will then
increase by the amount of this misalignment.
• If the screen footprint does not turn out square while the aluminium braces are being installed (step 3), the
glass can be pulled out from the full depth of the channel by up to 15mm to assist in squaring.
859 - 871mm
859 - 871mm

SHOWER SCREEN INSTALLATION STEPS
STEP 1.
STEP 2.
page 8 of 15
BRISTOL
SHOWER SCREENS
1
2
Φ6
INSIDE
Y
X
INSIDE
-6-
1
2
3
4
5
6
44
77
2
7
Size
1000
859-871
X
900
959-971
Size
1000
859-871
Y
900
959-971
22
66
page 8 of 15
BRISTOL
SHOWER SCREENS
1
2
Φ6
INSIDE
Y
X
INSIDE
-6-
1
2
3
4
5
6
44
77
2
7
Size
1000
859-871
X
900
959-971
Size
1000
859-871
Y
900
959-971
22
66
X 859 - 871mm
Y 859 - 871mm

SHOWER SCREEN INSTALLATION STEPS
STEP 3
STEP 4
page 9 of 15
BRISTOL
SHOWER SCREENS
3
4
-7-
11
14
88
0~10mm
1
2
3
Left Open
Right Open
22
4
1
2
3
page 9 of 15
BRISTOL
SHOWER SCREENS
3
4
-7-
11
14
88
0~10mm
1
2
3
Left Open
Right Open
22
4
1
2
3

page 10 of 15
BRISTOL
SHOWER SCREENS
5
6
-8-
55
33
1
13
S 4x10
T
2
6
114
114
6
6
11
2
page 10 of 15
BRISTOL
SHOWER SCREENS
5
6
-8-
55
33
1
13
S 4x10
T
2
6
114
114
6
6
11
2
SHOWER SCREEN INSTALLATION STEPS
STEP 5
STEP 6

SHOWER SCREEN INSTALLATION STEPS
STEP 7
STEP 8
page 11 of 15
BRISTOL
SHOWER SCREENS
7
8
-9-
12
18
1
2
18
3
88
page 11 of 15
BRISTOL
SHOWER SCREENS
7
8
-9-
12
18
1
2
18
3
88

SHOWER SCREEN INSTALLATION STEPS
STEP 9
STEP 10
page 12 of 15
BRISTOL
SHOWER SCREEN
9
10
-10-
617 16
517 16
4
17 16
3
22
1
2
19
19
7m m
4
22
16
1
2
17
12
3
page 12 of 15
BRISTOL
SHOWER SCREEN
9
10
-10-
617 16
517 16
4
17 16
3
22
1
2
19
19
7m m
4
22
16
1
2
17
12
3

SHOWER SCREEN INSTALLATION STEPS
STEP 11
STEP 12
page 13 of 15
BRISTOL
SHOWER SCREENS
11
12
-11-
ST4X16
ST4X16
1
2
3
4
1
2
ST4X10
ST4X10
3
4
page 13 of 15
BRISTOL
SHOWER SCREENS
11
12
-11-
ST4X16
ST4X16
1
2
3
4
1
2
ST4X10
ST4X10
3
4

SHOWER SCREEN INSTALLATION STEPS
STEP 13
STEP 14
page 14 of 15
BRISTOL
SHOWER SCREENS
2 4
13
14
-12-
1
2
3
21
20
20
21
20
21
4
13
3
1
13
3A3B
11
page 14 of 15
BRISTOL
SHOWER SCREENS
2 4
13
14
-12-
1
2
3
21
20
20
21
20
21
4
13
3
1
13
3A3B
11

SHOWER SCREEN INSTALLATION STEPS
STEP 15
STEP 16
page 15 of 15
BRISTOL
SHOWER SCREENS
15
-13-
16
SILICONE
Silicone inside and outside of
the shower (silicone not
supplied).
24 h
1
2
3
4
3
4
1
2
3
10
10 10
10
page 15 of 15
BRISTOL
SHOWER SCREENS
15
-13-
16
SILICONE
Silicone inside and outside of
the shower (silicone not
supplied).
24 h
1
2
3
4
3
4
1
2
3
10
10 10
10

All dimensions are nominal & subject to manufacturing tolerances & may vary +/-5mm, therefore we strongly recommend installation does not occur until after delivery. Decina reserves the right
to modify or change models without notice. For further information and for warranty T&C’s, please visit decina.com.au
WARRANTY TERMS & CONDITIONS
PLEASE LEAVE THIS MANUAL WITH THE END USER
PRODUCT WARRANTY TERMS
PREZZO Semi-frameless Angle Shower Screen 5 YEARS Replacement Products or Parts
1300 DECINADECINA.COM.AU
MAINTENANCE
This product should not be cleaned with abrasive materials.We recommend the use of soapy water or approved cleaners.
Damage caused by any improper treatment is not covered by the product warranty- refer to Warranty Conditions.
All Decina products are manufactured to the highest standards and guaranteed to be free of defects, subject to the conditions
outlined below. In addition to the statutory rights given under Australian Consumer Law, Decina offers the following extended
warranty periods from the date of purchase or handover:
The Decina warranty is only applicable when the product has been installed by a qualified tradesman, in full accordance with the
installation instructions and statutory requirements. The warranty specifically EXCLUDES damages discovered AFTER installation.
Decina’s responsibility for claims relating to impact damage ceases within 48 hours after delivery to the Decina re-seller’s store.
The extended warranties only apply to faults or defects in the product arisen solely from faulty materials or workmanship in the
products and does not apply to other defects for example from; damage, abuse, neglect or changes to the product supplied.
The warranty only extends to the supply of a replacement product or credit to the value of the purchase and excludes consequential
damage ensuing from the product application or use. The responsibility for the removal and replacement of the product is with the
installer and/or owner. Where the manufacturer “Decina” accepts that the product is at fault, the maximum contribution to the removal
and replacement costs will be $500.
Repairs of the Products other than by a Decina accredited or licensed service agent or technician are not covered.
In addition to this extended warranty, certain legislation (including the ACL) may give you certain rights which cannot be excluded,
restricted or
modified, this extended warranty must be read subject to such legislation and nothing in this warranty has the effect of excluding,
restricting or modifying those rights.
To make a warranty claim, please visit the Decina website decina.com.au/warranty-claim/ or email [email protected] and attach
the following documentation:
• Proof of purchase (original invoice from the supplier)
• Details of the warranty claim including the date of installation, installer’s details and head contractors
• Your contact details
If the Product has not been installed, please contact Decina to inspect the Product. If the claim is accepted, the Product can be
returned or exchanged. Note: The extended warranty only applies to the original owner and is not transferable. Decina reserves
the right to charge a service fee for any staff called to attend premises where products have been installed and the warranty claim
is not authorised.
Copyright Oct 2019. Decina Bathroomware Pty Ltd. ABN 39845 084 033