DeLonghi FAN HEATER User manual

FAN HEATER
INSTRUCTIONS FOR USE
We were thinking of you
when we thought of it
Proudly distributed by
De’Longhi
25 CARBINE ROAD
MT WELLINGTON
PO BOX 58056
GREENMOUNT
Auckland, New Zealand
Customer Service Ph: [phone]
Fax: [phone]
e-mail:[email protected]
Australia
P.O.Box 597
Riverwood NSW 2210
Customer Service Ph: 1800 126659
Fax: [phone]
e-mail: [email protected]

2
FUNCTION SELECTOR
1
2
1
2
AMBIENT THERMOSTAT
ELECTRICAL CONNECTION
-Before plugging into the mains, make sure the voltage of your mains supply corresponds to
the value in Volts indicated on the appliance.
-Make sure the mains socket is rated at 10/16 Amps.
-THIS APPLIANCE COMPLIES WITH DIRECTIVE 89/336/EEC AND D.M. 476/92 ON
ELECTROMAGNETIC COMPATIBILITY.
INSTALLATION
The appliance is designed for portable use only.
OPERATION AND USE
Models with function selector and thermostat
-Summer mode (ventilation only): turn the thermostat clockwise as far as it will go to the /6 posi-
tion.
-Low power operation: turn the function selector to position 1 (the pilot light switch on).
-High power operation: turn the function selector to position 2.
-Switching off: turn the function selector to the ” ●“ position and the thermostat knob to the
position, then unplug from the mains.
Thank you for choosing this De’Longhi fan heater. To get the very best out of yuor new
fan heater it is advisable to read these instructions before using it. This will ensure that you
gain optimum results and use the appliance safely.
3
SWITCH
3

3
Setting the thermostat:
When the room has reached the desired temperature, turn the right-hand thermostat knob
(if fitted) slowly anti-clockwise until the appliance goes off and no further. The thermostat will
then keep room temperature at the selected level automatically.
FROST PREVENTION CYCLE
Turn the left-hand knob to position 2, then turn the right-hand thermostat knob to the
position . The appliance is set to maintain a temperature of about 5°C in the room with mini-
mum energy consumption.
Models with switch
-Heating at low power: press the “
- “ switch (the red zone is visible on the switch).
-Heating at high power: press both switches (the red zone is visible on the switches).
-Turning the appliance off: turn off both switches.
You should always unplug the appliance from the mains when not in use.
MAINTENANCE
- Always remove the plug out of its socket before cleaning the heater.
- Periodically clean the air intake and outlet grilles.
- Do not use abrasive cleaning products or solvents.
WARNINGS
-Do not use the heater in the immediate surrondings of a bath, a shower or a swimming pool.
-Always use the heater in an upright position.
-Do not use the heater to dry your laundry. Never obstruct the intake and outlet grilles (dan-
ger of overheating).
-Do not positon the heater in close proximity to curtains or other combustible materials.
-The heater must be positioned at least 50 cm from furniture or other objects.
- The use of extension leads is not reccomended, however if it is necessary then follow care-
fully the extension lead’s instructions, and most importantly ensure that the extension lead is
correctly rated in accordance with the heater being used and NEVER overloaded.
-When the appliance is used in portable version, do not place it up against walls, furniture, cur-
tains, etc.
-The appliance must be installed so that the switches and other controls can not be reached
by persons using the bath tub or the shower.
-This appliance comes with a Y-type connection. If the supply cord is damaged, it must be
replaced by the manufacturer or its service agent or a similarly qualified person in order
to avoid a hazard.
- The appliance must not be located directly below a socket-outlet.
- The appliance is not intended for use by young children or the infirm persons without super-
vision.
- Young children should be supervised to ensure that they do not play with the appliance.
-Do not cover the appliance while it is functioning in order to avoid overheating with the
attendant risk of fire.
- Do not use the appliance in rooms less than 4 m2in area.
The heater is fitted with a safety device which will switch off the heater in case of accidental
overheating (eg. obstruction of air intake and outlet grilles, motor turning slowly or not at all).
To reset, disconnect the plug from the power for a few minutes, remove the cause of overhea-
ting then plug the appliance in again.
Important: never for any reason cover the appliance during operation as this could
lead to dangerous overheating.
2
1
2

5714010100/11.04