DeLonghi HFX30 Series User manual

www.delonghi.com 5711413131_00_0317 Printed in China

INSTANT CERAMIC HEATER
Instructions for use. Keep these instructions
Visit www.delonghi.com for a list of service centers
near you.
ELECTRIC CHARACTERISTICS
120 V~ 60 Hz1500 W
CALENTADOR DE CERAMICO
INSTANTANEO
Repase y guarde estas instrucciones.
Lea cuidadosamente este instructivo antes de usar
su aparato.
Visite www.delonghi.com para ver la lista de centros
de servicios cercanos a usted.
CARACTERISTICAS ELECTRICAS:
120 V~ 60 Hz1500 W
HFX30 Series

2
EN ES
page 4 page 7

3
A
C
B
E
D

45
IMPORTANT
SAFEGUARDS
Read all instructions carefully before using the appliance.
Specically:
Danger!
Failure to observe the warning may result in life threatening
injury by electric shock.
- Do not operate any heater with a
damaged cord or plug or after the
heater malfunctions, has been dropped
or damaged in any manner. Return
heater to authorized service facility for
examination, electrical or mechanical
adjustment, or repair.
- This heater is not intended for use in bath-
rooms, laundry areas and similar indoor lo-
cations. Never locate heater where it may fall
into a bath tub or other water container.
- Do not use this heater in the immediate sur-
roundings of a bath, a shower or a swimming
pool.
- Do not insert or allow foreign objects to enter
any ventilation or exhaust opening as this
may cause an electric shock, re, or damage
the heater.
- CAUTION: to prevent electric shock
match wide blade of plug to wide slot,
then fully insert.
- CAUTION: In order to avoid a hazard due to
inadvertent resetting of thermal cutout, this
appliance must not be supplied through an
external switching device, such as a timer,
or connected to a circuit that is regulary
switched on and o by the utility.
Important!
Failure to observe the warning could result in injury or dam-
age to the appliance.
- The appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or
lack of experience and knowledge, unless
they have been given supervision or instruc-
tion concerning use of the appliance by a
person responsible for their safety. Children
should be supervised to ensure that they do
not play with the appliance.
- Extreme caution is necessary when any heater
is used by or near children and whenever the
heater is leftoperating and unattended.
- Always unplug heater when not in use.
- Use this heater only as described in this
manual. Any other use not recommended
by the manufacturer may cause re, electric
shock, or injury to persons.
- The heater must not be located immediately
below a socket-outlet.
- To prevent overload and blown fuses, be
sure that no other appliance is plugged into
the same outlet (receptacle) or into another
outlet (receptacle) wired into the same cir-
cuit.
- Be sure that the plug is fully inserted into an
appropriate outlet. Please remember that
outlets also deteriorate due to aging and
continuous use: check periodically if signs of
overheating or deformations are evi-denced
by the plug. Do not use the outlet and CALL
your electrician.
Danger of burns!!
Failure to observe the warning could result in burns or scalds.
-This heater is hot when in use. To avoid
burns, do not let bare skin touch hot surfaces.
Use handle when moving this heater. Keep
combustible materials, such as furniture, pil-
lows, bedding, papers, clothes, and curtains
at least 3 feet (0,9 m) from the front and top
of the heater and keep them away from the
sides and rear.
- Do not run cord under carpeting. Do not
cover cord with throw rugs, runners, or the
like. Arrange cord away from trac area and
where it will not be tripped over.
- To prevent a possible re, do not block air in-
takes or exhaust in any manner. Do not use on
soft surfaces,like a bed, where openings may

45
become blocked.
- A heater has hot or arcing or sparking parts
inside. Do not use it in areas where gasoline,
paint, or ammable liquids are used or stored.
- It is normal for the heater’s plug and cord to
feel warm to the touch. A plug or cord which
becomes hot tothe touch or becomes distort-
ed in shape may be a result of a worn electri-
cal outlet. Worn outlets or receptacles should
be replaced prior to further use of the heater.
Plugging heater into a worn outlet / recep-
tacle/ may result in overheating of the power
cord or re.
- If the supply cord is damage, it must be re-
placed by the manufacturer, its service agent
or similarly qualied person in order to avoid
a hazard.
- WARNING: Do not cover the appliance while
it is functioning in order to avoid overheating
which may cause risk of re.
Please note:
This symbol indicates recommendations and important infor-
mation for the user.
-If your appliance is equipped with a poly-
thene tape used as carry handle, remove it
before connecting appliance to the outlet.
- Do not use outdoors.
- To disconnect heater, turn controls to o, then
remove plug from outlet.
- Connect to properly polarized outlets only.
- This heater is not intended for use with an
extension cord or outlet strip. Plug the cord
directly into an appropriate wall receptable.
- Check that neither the appliance nor the
power cable have been damaged in any way
during transportation.
- Do not use the appliance in rooms with a oor
area of less than 43 square feet (4mq).
- Make sure that no pieces of polystyrene or
other packaging material have been left on
the appliance. It may be necessary to pass
over the appliance with a vacuum cleaner.
- When switching on the appliance for the rst
time, allow it to run at full power for at least
two hours to get rid of the unpleasant smell.
Make sure that the room in which the appli-
ance is located is well ventilated during this
operation. It is normal for the appliance to
emit small cracking sounds when you turn it
on.
SAVE THESE
INSTRUCTIONS
For Household use only
DESCRIPTION
A Thermostat
B Function selector
C Indicator light
DTip over switch (certain models only)
E Foldable support
USE
Installation
The appliance can be used on any horizontal surface.
Do not overload the electrical circuit. Avoid using the same
socket for other appliances.
Electrical connection
- Before plugging into the outlet, make sure the voltage
of your power supply corresponds to the valueV indica-
ted on the appliance and that the socket and power line
are appropriate for the load required.
- THIS APPLIANCE COMPLIES WITH DIRECTIVE 2004/108/
EC ON ELECTROMAGNETIC COMPATIBILITY.
Functioning and use
Please note: pull out the support outwards by placing
ngers in the slot (see gure on page 3). If the support isn’t
pulled out, the product will not stand up and fall down.
Always operate the heater in upright position only.
Any other position could create a hazardous situation.
1. Plug the appliance into the outlet.
2. Turn the thermostat dial to maximum.
3. Summer mode (fan only): turn the function selector to
the position.
4. Low power operation: turn the function selector to posi-
tion 1(in models with two fan speeds, the fan operates
at minimum).

6
5. High power operation: turn the function selector to po-
sition 2(the fan operates at maximum).
6. Switching o: turn the function selector to the“0”posi-
tion.
Setting the thermostat
Position the thermostat on maximum. When the room has
reached the required temperature, turn the thermostat dial
slowly counterclockwise until you hear a click and the fan
goes o. The thermostat will then keep room temperature at
the selected level automatically.
Frost prevention mode
With the function selector in position 2and the thermostat
dial in position , the appliance maintains room tempera-
ture at about 41°F (5°C), preventing freezing with minimal
energy consumption.
MAINTENANCE
- Always unplug from the outlet before cleaning.
- Clean the air intake and outlet grilles regularly.
- Do not use abrasive products or solvents to clean the
appliance.
SAFETY FUNCTIONS
-Safety device: the appliance is tted with a safety
device that switches it o in the event of accidental
overheating (e.g. obstruction of air intake and outlet
grilles, motor turning slowly or not at all).
To reset, unplug the appliance from the outlet for a few
minutes, remove the cause of overheating, then plug in
again. If the appliance doesn’t work please contact the
De’Longhi Customer Service.
- Tip-over safety device: certain models are tted
with a tip-over switch (D) which turns the appliance o
if it falls over. To restart the appliance, simply place it
upright again.
PROBLEM CAUSE SOLUTION
The appliance doesn’t work Be sure it is plugged in and that the
electrical outlet is working.
Check for any obstruction.
The function selector is in the ”0” po-
sition.
The thermostat may be set too low.
Plug into the outlet.
Remove the obstruction, unplug the
heater and let the appliance cool down.
If the appliance doesn't work please
contact the De longhi toll free number.
Turn the function selector to the position
or“1”or ”2”.
Turn the thermostat clockwise to a higher
setting until the heater restarts.
The tip-over switch has been activated
(certain models only).
Make sure the appliance is standing
upright on a at surface, if the problem
persists contact our toll free number to
assist you.
TROUBLESHOOTING