DeLonghi KENWOOD multione KHH30 Series Manual

KHH30seriesmultione
DisassemblyProcedure

Remove the outlet cover.
2
Turn the drive coupling clockwise to remove.
photo1 photo2

Remove the single screw securing the top cover.
IMPORTANT:
The top cover is secured by clips/lugs around
the moulding (see photo7).
To avoid damage to the mouldings, please take
care when releasing these clips.
A plastic spatula would be the recommended
‘tool’.
With the head of the machine opened & locked, use one hand to hold/grip
the top where shown, and the other hand to firmly press & detach the top
cover at the corner (this can be done from either side)...
3
photo3
photo4

photo6 Step 2
4
photo5 Step1

…once the top cover is loose, use a plastic spatula to free all clips around the top cover & remove it.
photo8
5
photo7

IMPORTANT: on re-assembly of the top cover ensure the
interlock/s are located correctly..
6
..and the top cover is correctly seated into
position at the back.
photo9 photo10

Position of main locating lug/s on either side, and all
clip points around the moulding.
7
Turn the M5 nut anti-clockwise to remove.
photo11 photo12

8
To remove the medium speed outlet pulley, pull up on the pulley and place a flat screwdriver under it, as shown, then twist to
release. On re-assembly, apply light pressure to snap the pulley back into position.
IMPORTANT: to avoid damage to the drip tray, the screwdriver should be placed in the cut-away section, as shown.
Do not position the screwdriver on the top edge of the drip tray.
photo13

9
The 4 screws highlighted secure the chassis
to the lower body. To remove the gearbox & motor as a complete assembled unit,
first remove the 4 chassis screws.
photo14 photo15

Next remove the 8 screws securing the base moulding.
10
Disconnect all leads to the PCB. 3 screws secure the
PCB housing - 4 TX10 screws secure the PCB.
photo16 photo17