Delta Children 7586 B User manual

Changing Table
APRIL 4, 2014, 21101, R5
Style #:
Lot:
Date:
___________
___________
___________
©2014 DELTA ENTERPRISE CORP.
B
Conforms to
ASTM F2388
Safety Standards
Consumer Care:
www.DeltaChildren.com
Delta Children’s Products
114 West 26th Street
New York, NY 10001
Tele.212-645-9033
REV
THIS PRODUCT IS NOT INTENDED FOR
INSTITUTIONAL OR COMMERCIAL USE.
Read all instructions before assembly and use.
KEEP INSTRUCTIONS FOR FUTURE USE.
ADULT ASSEMBLY REQUIRED
Due to the presence of small parts during assembly, keep out of
reach of children until assembly is complete.
When contacting Delta Consumer Care please reference the above information. Before contacting Delta
Consumer Care please ensure that the information above matches the information found on the label on
the Top Shelf, please reference the information found on the product when contacting Delta Consumer
Care.
To register your product for important safety alerts and updates to your product please visit
www.DeltaChildren.com and click on Product Registration.

2
WARNING
FALL HAZARD - to prevent death or serious injury, always keep child within arm’s reach.
Read all instructions before use of the changing table.
KEEP THESE INSTRUCTIONS IN A SAFE PLACE FOR FUTURE USE.
Inspect the changing table periodically. Do not use the changing table if it is damaged or
broken. Contact Delta Children’s Products with any questions.
Tighten all loose screws and bolts before each use.
The maximum recommended weight of the child is 30lbs for the changing table.
Use only the pad provided by Delta Children’s Products.
Always secure the pad to the changing surface by inserting the strap through the hole in
the middle of the pad. See Instructions.
WARNING: Changing Table
NOTES ON ASSEMBLY:
-During the assembly process whenever using screws or bolts, check each by placing the screw/bolt on
the diagram of the item which is drawn actual size and design. Be sure to use the proper size and shape
specified in the instructions.
-To assemble this unit you may be required to place the unit on it’s side and face. It is strongly
recommended that assembly is done on a soft, non-abrasive surface to avoid damaging the finish.
NOTES ON CARE AND MAINTENANCE:
- Do not scratch or chip the finish.
- Inspect the product periodically, contact Delta Children's Products for replacement parts or questions.
- Do not store the product or any parts in extreme temperatures and conditions such as a hot attic or a
damp, cold basement. These extremes can cause a loss of structural integrity.
-To preserve the luster of the high quality finish on your product, it is recommended to place a doily or
felt pad under any items you place on the finish.
-Clean with a damp cloth, then a dry cloth to preserve the original luster and beauty of this fine finish.
-Do not use abrasive chemicals.
-Do not spray cleaners directly onto furniture.
-Lift slightly when moving on carpeting to prevent leg breakage.
-Use of a vaporizer near furniture will cause wood to swell and finish to peel.
NOTES ON USE:
Keep children and others safe by following these simple rules:
- Do not allow any child to play on furniture
- Do not allow climbing on any piece of furniture.
- Do not allow hanging from any piece of furniture.
- Always monitor your child’s activity when in the nursery.

3
PARTS: MAKE SURE THAT ALL PRE-ASSEMBLED PARTS ARE TIGHT.
A. Left End Frame x1
B. Right End Frame x1 C. Back Rail Top x1
D. Back Rail Middle x1
E. Lower Rails x4
F. Front Rail Top x1
G. Top Shelf x1
H. Lower Shelves x2
M4 Allen Wrench x1
L. Foam Pad x1
HARDWARE AND TOOLS.
No drills necessary. Do not
use power screwdriver.
J. M6 x40 mm Bolt x 14

4
A
Attach the (1) Back Rail Middle (Part D) & (1) Front Rail Top (Part F) BE SURE THE GROOVES ARE
TOWARDS THE BOTTOM OF THE UNIT AND FACING INWARD. & (4) Lower Rails (Part E) to the
Left End Frame (Part A) using (6) M6 x40 mm Bolts (Part J). Tighten with the M4 Allen Wrench.
D
F
E
E
J
J
J
J
J
J
A. Left End Frame x1
D. Back Rail Middle x1
E. Lower Rails x4
F. Front Rail Top x1
M4 Allen Wrench x1
J. M6 x40 mm Bolt x 6
Step 1
Section 1: Changing Table Assembly
Parts and tools required to complete step.

5
Lay the Left End Frame on the floor, rails up. Slide the Top Shelf (Part G) in the grooves on the Top
Rails, into the groove on the Left End Frame, insert the pins on the top shelf into the holes in the rails.
GENTLY PULL THE RAILS APART. Slide (2) Lower Shelves (Part H) in the grooves on the Lower
Rails, into the groove on the Left End Frame.
From Step 1
H
H
G
D / F
G
G. Top Shelf x1
H. Lower Shelves x2
Step 2
Section 1: Changing Table Assembly
Parts and tools required to complete step.

6
Attach the Right End Frame (Part B) to the Rails using (6) M6 x40 mm Bolts (Part J). Tighten with the
M4 Allen Wrench.
J
J
JB
J
J
From Step 2
B. Right End Frame x1
M4 Allen Wrench x1
J. M6 x40 mm Bolt x 6
Step 3
Section 1: Changing Table Assembly
Parts and tools required to complete step.

7
Insert the tenon of the Back Rail Top (Part C) into the slot on the top of the Back Rail Middle (Part D),
Then insert (2) M6 x40 mm Bolts (Part J),Through the rear legs into the threaded insets onto the
Back Rail Top (Part C). Tighten with the M4 Allen Wrench.
J
J
C
D
From Step 3
C. Back Rail Top x1
M4 Allen Wrench x1
J. M6 x40 mm Bolt x 2
Step 4
Section 1: Changing Table Assembly
Parts and tools required to complete step.

8
1. Check that the bolt securing the strap is tight using
the M4 Allen Wrench.
2. Insert the strap through the hole in the Foam Pad (Part L).
3. Place Foam Pad (Part L) on Top Shelf (Part G).
L
G
L
From Step 4
L. Foam Pad x1
Step 5
Section 1: Changing Table Assembly
Parts and tools required to complete step.

9
RESTRAINT HARNESS SYSTEM USE:
. PLACE THE INFANT ON THE CHANGING TABLE FOAM PAD.
. POSITION THE RESTRAINT HARNESS OVER THE MIDDLE OF THE INFANT’S
TORSO AND INSERT THE BUCKLED ENDS INTO EACH OTHER UNTIL THE LOCK
SHUT WITH A CLICK.
. GENTLY PULL THE LOOSE END OF THE STRAP TO LIGHTLY SNUG THE
RESTRAINT HARNESS AROUND THE INFANT.
MAINTENANCE
. CHECK FASTENERS PERIODICALLY FOR TIGHTNESS. DO NOT OVER TIGHTEN.
THIS MAY CAUSE DISTORTION OR BREAKAGE.
WARNING : FALL HAZARD
ALWAY KEEP CHILD WITHIN ARMS REACH.
TO FASTEN STRAP - PUSH BUCKLE SIDE TOGETHER
BE SURE BUCKLE IS FULLY FASTENED TO
SECURE CHILD SAFFELY
TO RELEASE PRESS BOTH TABS AND PULL APART
Final
Section 1: Changing Table Assembly

Warranty: This Delta product is warranted to be free from defects for a period
of 90 days from the date of purchase under normal use. This warranty extends
only to the original retail purchaser and is valid only when supplied with proof of
purchase, or if received as a gift, when the registration is on file with Delta.
Please do not return this item to the store before contacting
us about missing parts or with any questions.
To register your product for important safety alerts and updates to
your product please visit www.DeltaChildren.com
To report a problem, please log on to www.DeltaChildren.com and
click the Consumer Care Tab, or contact us by phone at
[phone].
In the event that you need to contact our customer service
department please have the Style Number and Lot Number available.
Use the space below to make note of those numbers. They can be
found on the label on the Top Shelf.
Lot No. : _______________________
Pack Date:_____________________
Date of Purchase: _____________ (you should also keep your receipt)
COLOR FTY
REV
STYLE No: 7586 B
Consumer Care:
www.DeltaChildren.com
Delta Children’s Products
114 West 26th Street
New York, NY 10001
Tele.212-645-9033