adaptor on the record spindle.
2. Choose the desired playing speed using the speed selection switch between 33.3 and
45.
3. Slide the Function switch (6) to Phono position.
4. Release the tone arm lock.
5. Raise the arm with your hand lightly.
6. Place the stylus vertically over the first track of the record, the turntable will start turning
automatically.
7. Put down the stylus slowly on to the record to play.
8. Adjust the volume to the desired level.
9. When a record comes to the end, the turntable will stop automatically if the auto-stop switch is in the ON
position. If the switch is in the off position then it will keep revolving until the tone is returned to the tone arm
rest.
10. Lift up the tone arm and put it on the rest when finished.
11. Replace the protective cap on the stylus and close the tone arm lock.
12. Turn off power at mains.
Amplifier connection (If required)
Whilst you can listen to your new turntable using the built in speakers you may wish to connect it to your existing Hi
Fi system. Connect the audio plugs to the Line input on your mixer or amplifier using an RCAcable (not supplied)
- Red plug into R/H channel input.
- White plug into L/H channel input.
Using headphones (Not included)
Inserting the plug of your headphones into the Headphone jack(4) will enable you to listen in private.
READ THIS IMPORTANT INFORMATION BEFORE USING YOUR HEADPHONES.
1. Avoid extended play at very high volume as it may impair your hearing.
2. If you experience ringing in your ears, reduce the volume or shut off your unit.
3. Keep the volume at a reasonable level even if your headset is an open-air type designed to allow you to hear
outside sounds. Please note that excessively high volume may still block outside sounds.