Dewenwils HOSL05C User manual

SKU: HOSL05C
[Instruction Manual]
Low Voltage Transformer
Thank you for your purchase.
Please contact us if you have any questions.
We will get back to you within 24 hours.
Email: [email protected]
Please attach your Order ID so that
we can serve you better.

1.Disconnect from power source prior to opening the case.
2.Do not use the transformer with an extension cord.
3.Make sure all unused taps (leads) are separately insulated.
4.Do not install within 5 ft of a pool or spa.
5.Do not exceed total fixture load of 300VA.
Warning:
Product Layout
01
All wiring and installation must be in accordance with local
building and electrical codes. Always disconnect transformer
from power source before performing work on lighting system.
Calculate lighting capacity correctly – total load of fixtures
may not exceed 300VA.
High Voltage Wiring
Compartment
Ground Terminal
Low Voltage Wiring
Compartment
Circuit Breaker
Mounting brackets

Installation
02
1. Turn off the main circuit.
2. Remove the metal cover by a
screwdriver (NOT Included),
and take out the mounting
brackets, screws and anchors
inside.(Figure 1)
3. Unscrew the top and bottom screws
on the back of the transformer, install
the mounting brackets and tighten the
screws again.
Note: Pay attention to the right direction
of the two mounting brackets when
installing. (Figure 2)
4.Use Screws and Anchors to fix the
transformer on the wall (at least 1ft
above the ground), making sure that
the Wiring Compartments are facing
down.(Figure 3)
Figure 1
Upward
Downward
Figure 2
Figure 3

5.Use electrical tape to connect the
Black Wire and White Wire of the
High Voltage Wiring Compartment
with your live and neutral wires
seperately, then place these
connected wire in the High Voltage
Wiring Compartment.(Figure 4)
6.Use the included wiring caps to connect
the output line of the transformer with
your load input line, then place the
connected line in the Low Voltage
Wiring Compartment.(Figure 5)
Note: (1) If the load has a ground wire,
connect the ground wire to the Ground
Terminal.
(2)Do not remove the terminal block of
the unused output line port, or it will
cause short circuit.
7.Turn on the main circuit.
8.Use a screwdriver to install the metal
cover on the front of the transformer.
(Figure 6)
03
Figure 4
Figure 5
Figure 6

One Year Limited Warranty
DEWENWILS warrants this product to be free from defects in material and
workmanship for a period of one year from the date of purchase.
Warranty is void if damage is caused by misuse or improper installation.
Email: [email protected].
Our dedicated customer service team will get back to you within 24 hours.
04
- Input Voltage: 120VAC, 60Hz
- Output: 12/13/14VAC
- Max Power Rating: 300W
Specifications
Circut Breaker
If a circuit breaker occurs, immediately disconnect the transformer from the
power source. Common causes for a circuit break are:
• Low voltage wires are incorrectly connected to transformer output terminals.
• Overload or short circuit (bare wires touching) occurs somewhere along
cable.
• Fixtures are incorrectly installed along the cable.
• Lamp load along a circuit exceeds 300VA.
Make all repairs to the lighting system before reconnecting the transformer
to the power source. After the problem has been determined and solved,
reset the breaker by flipping the Circuit Breaker.