dg casa SOLOMAN 12050-K User manual

SOLOMAN PLATFORM BED
ASSEMBLY INSTRUCTION
12050-K

WARNING
Seller and Manufacturer disclaim all and any liability for
property damage, personal injury, or loss, direct, indirect, or
incidental, resulting from the incorrect assembly, inadequate
maintenance, improper use, or neglect of this product.
Request a replacement by logging into the marketplace
account in which the purchase was made and sending a
message to the seller. To assist in expediting the request
attach applicable images relevant to the request and/or
part number and quantity.
• Keep these assembly instructions for future reference.
• Do not use this product if there are missing parts,
damaged, or broken until repairs are made and/or factory
replacement parts are installed.
• Check all packing material carefully for small hardware
that may have become loose inside the carton
during shipment.
• Identify and count all hardware and parts to compare with
parts and hardware list.
• Follow assembly instructions closely. Improper assembly
can result in personal or property damage.
• Secure all bolts and screws before use.
• Every 90 days check all bolts and screws are secured.
• Some parts may have sharp corner or edges and may
be heavy.
• Do not use or store this product near open flames or
around flammable chemicals.
• When placing contents on non-carpeted flooring, it’s
recommended to use floor protection such as an area rug
or furniture pads. These are not included with the purchase.
NOTICE
REPLACEMENT PART OR HARDWARE REQUEST:
TOOLS REQUIRED:
ALLEN WRENCH
(PROVIDED)
PHILLIPS SCREWDRIVER
(NOT PROVIDED)
12050-K

HARDWARE
i
j k
gh
ba c
d
FLAT WASHER M6
16 PCS
M6 x 50
16 PCS
M4 x 32MM
26 PCS
ef
ALLEN KEY M4
1 PC
ALLEN KEY M5
1 PC
M8 x 50
8 PCS
M8 x 20
8 PCS
M6 x 30
4 PCS
M6 x 60
10 PCS
FLAT WASHER M8
8 PCS
SUPPORT LEG ADJUSTER
10 PCS

SOLOMAN PLATFORM BED PARTS
A
B
C
D
E
F
G
HEADBOARD 1 PC
SIDE RAIL 2 PCS
SLAT 13 PCS
LEG 4 PCS
CORNER BRACKET 4 PCS
SUPPORT LEG 10 PCS
CENTER RAIL
SLAT SUPPORT 2 PCS
FOOTBOARD 1 PC

STEP 1
STEP 2
ASSEMBLY INSTRUCTION
A
A
D
HEADBOARD
FOOTBOARD
REPEAT THIS STEP FOR EACH OF THE FOUR
CORNERS TO SECURE THE HEADBOARD,
SIDE RAIL, AND FOOTBOARD.
j
a
c
e
k
j
a
c
C
D
k
d
f
INSTALL PART (C) TO PART (D)
AND REPEAT FOR EACH CORNER.

STEP 3
j
b
GF
E
h
ATTACH PART (h) TO PART (E), THEN ATTACH PART (b) THROUGH PART (G),
PART (F), PART (E), AND TIGHTEN. REPEAT THIS STEP TO INSTALL ALL OF
PART (E) TO PART (G).
ROTATE PART (H) CLOCKWISE OR
COUNTER CLOCKWISE TO ADJUST
THE SLAT HEIGHT FOR PROPER
MATTRESS SUPPORT.

STEP 4
COMPLETED
ASSEMBLY
j
F
i
g
G
ATTACH THE ASSEMBLED SLAT TO
BED FRAME AND ADJUST PART (h)
IN STEP 3 ACCORDINGLY.