Digital Watchdog B3252DIR Series User manual

ABOUT MANUAL
Before installing and using the camera, please read this manual carefully.
Be sure to keep it handy for future reference.
B3252DIR
Bullet Camera
07132012

PRECAUTIONS
Do not open or modify.
Do not open the case except during maintenence and installation,
for it may be dangerous and can cause damages.
Do not put objects into the unit.
Keep metal objects and flammable substances from entering the camera.
It can cause fire, short-circuits, or other damages.
Be careful when handling the unit.
To prevent damages, do not drop the camera or subject it to shock or vibration.
Do not install near electric or magnetic fields.
Protect from humidity and dust.
Protect from high temperature.
Be careful when installing near the ceiling of kitchen or a boiler room,
as the temperature may rise to high levels.
Cleaning:
To remove dirt from the case, moisten a soft cloth with a soft detergent solution and wipe.
Mounting Surface:
The material of the mounting surface must be strong enough to support the camera.
FCC COMPLIANCE
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference, when the equipment is operated in a residential environment. This
equipment generates, uses, and radiates radio frequency energy; and if it is not installed and used in
accordance with the instruction manual, it may cause harmful interference to radio communications.
WARNING: Changes or modifications are not expressly approved by the manufacturer.
2

TABLE OF CONTENTS
Introduction
Installation
Troubleshooting
Warranty Information
Specifications
Features
Dimensions
Mount Installation Instructions
Connecting to Monitors
4
5
6
7
8
9-10
11
3

4
■1/3" Samsung CCD
■420TV Lines
■
3.6mm Fixed Lens
■35ft Range IR with Intelligent Camera Sync
■AWB (AutoWhite Balance)
■Clear Image
■Wide OperatingVoltage (8VDC~18VDC)
■Low Power Consumption
■Weatherproof Design
■Removable Sunshield
■
■Small and Conpact Size
■
■12VDC Transformer Included
FEATURES*

5
DIMENSIONS IN MILLIMETERS*
66.0
54.0
4.0
120.0°
49.0
110.0
8.7
70.2
64.5
151.8±2.0

6
INSTALLATION*
E
1. Mark and drill the holes on the surface
where the screw holes of the Bracket
[F] will be mounted.
2. Mount the Bracket [F] onto the wall
using the Screws [D].
3. Assemble the Camera [C] and the
Bracket [F].
4. Loosen the Fixed Screw [E] to adjust
the direction of the camera.
5. After it is adjusted to the desired
position, tighten the Fixed Screw [E]
6. Loosen the Top Camera Screw [A] to
adjust the position of the Sun Cover
[B].
7. Tighten the Top Camera Screw [A]
after the Sun Cover [B] has been
adjusted to its desired position.
A
B
C
D
F

7
CONNECTION*
CAUTION : CHECK FOR POLARITY WHEN USING A DC12V POWER SUPPLY.
110.0
64.5
70.2
8.781.1
BNC JACK
VIDEO(YELLOW)
VCC(RED)

8
FOR NO VIDEO
FOR OUT-OF-FOCUS VIDEO
Before sending your camera for repair, check the following or contact our technical
specialist.
Check the coaxial cable and make sure it is connected securely.
Check the lens’ iris adjustment at the camera’s OSD menu.
Check the power supply and make sure the camera has the proper voltage and
current.
Check the clear dome cover and the lens for dirt or fingerprints. Use a soft cloth and
gently clean. Check the lens’ manual focal and zoom adjustment. The use of a field
test monitor is recommended.
TROUBLESHOOTING

9
WARRANTY INFORMATION*
Digital Watchdog (referred to as “the Warrantor”)
warrants Camera Series against defects in
materials or workmanship as follows.
LABOR : For the initial five (5) years and one (1) year on LED
from the date of original purchase, if the camera is determined to be defective,
the Warrantor will repair or replace the unit, with new or refurbished
product at its option, at no charge.
PARTS : In addition, the Warrantor will supply
replacement parts for the initial five (5) years and one (1) year on LED.
To obtain warranty or out of warranty service,
please contact a Technical Support Representative at
1-866-446-3595 Monday through Friday from 8:30AM to 8:00PM Eastern.
A purchase receipt or other proof of the original purchase date is required
before warranty service is rendered. This warranty only covers failures due to
defects in materials and workmanship which arise during normal use.
This warranty does not cover damage that occurs in shipment or failures
caused by products not supplied by the Warrantor or failures
which result from accident, misuse, abuse, neglect, mishandling,
misapplication, alteration, modification, faulty installation, set-up adjustments,
improper antenna, inadequate signal pickup, maladjustment of consumer controls,
improper operation, power line surge, improper voltage supply, lightning damage,
rental use of the product or service by anyone other than an authorized repair
facility or damage that is attributable to acts of God.

10
LIMITS AND EXCLUSIONS*
There are no express warranties except as listed above.
The Warrantor will not be liable for incidental or consequential
damages (including without limitation and damage to recording media)
resulting from the use of these products, or arising out of any breach
of the warranty. All express and implied warranties, including the
warranties of merchantability and fitness for particular purpose,
are limited to the applicable warranty period set forth above.
Some states do not allow the exclusion or limitation of incidental
or consequential damages, or limitations on how long an implied
warranty lasts, so the above exclusions or limitations may not
apply to you. This warranty gives you specific legal rights, and you
may also have other rights that vary from state to state.
If the problem is not handled to your satisfaction,
then write to the Address listed on the back page.
Service calls which do not involve defective materials or
workmanship as determined by the Warrantor in its sole
discretion are not covered. Costs of such service calls are
the responsibility of the purchaser.