
QuickStart
Guide
QuickStart
Guide
QuickStart
Guide
Rev Date: 04/20
Copyright © Digital Watchdog. All rights reserved.
Specifications and pricing are subject to change without notice.
Quick Start Guide
INSTALLING THE MOUNTING ACCESSORY
Attach the wall mount bracket to the structure using suitable tapping screws (PLASTIC ANCHOR, PTS1 M8x40L)
as illustrated in the figure. The wall bracket must be attached to a structure such as hardwood, wall stud, concrete
or a suitable material capable of supporting the final mount assembly. The installer may need to change the
method of mounting or hardware used depending on the wall material.
LED ILLUMINATOR INSTALLATION WITH SINGLE WALL MOUNT BRACKET
1 2
3
Use the bracket as a template to mark and drill the necessary holes in the wall. *NOTE: wall anchors are for
illustration only, and are not included.
With the bracket secured to the wall attach the illuminators with the supplied M6 nuts and bolts. For each
illuminator attach the center bolt first then rotate the illuminators to the required horizontal position, then secure
with the remaining nut and bold in one of the outer holes.
Vertical adjustment can be made via the two hex bolts on each side of the illuminator.
NOTE: Recommended fasteners (not included):
• Head size: minimum 0.6”
• Screw or bolt diameter: maximum 0.5”
• Fastener strength: minimum 10 lb.