Digitus GreyRapid N DN-7049-1 User manual

Quick Installation Guide
DN-7059 – WIRELESS LAN BROADBAND ROUTER
Package Contents .......................................................................... Page 1
Build Network Connections ......................................................... Page 2
Network Setup ............................................................................... Page 3
Package Contents
Before you starting to use this router, please check if there’s anything missing in the
package, and contact your dealer of purchase to claim for missing items:
Broadband router (main body, 1 pcs)…………………………………………….. 1
Quick installation guide (1 pcs) …………………………………………………… 2
User manual CDROM (1 pcs) …………………………………..………………… 3
A/C power adapter (1 pcs) …………………………………….....……………….. 4

Build Network Connections
Please follow the following instructions to setup wireless router:
1. Connect your xDSL / cable modem to the WAN port of router by Ethernet cable.
2. Connect all your computers, network devices (network-enabled consumer devices
other than computers, like game console, or switch / hub) to the LAN port of the
router.
3. Connect the A/C power adapter to the wall socket, and then connect it to the ‘Power’
socket of the router.

Please check all LEDs on the front panel. ‘PWR’ LED should be steadily on, WAN and
LAN LEDs should be on if the computer / network device connected to the respective
port of the router is powered on and correctly connected.
If ‘PWR’ LED is still off and you’re sure that all cable connections are connected
properly, please contact your dealer of purchase for assistance.
Network Setup
Please use the web browser to configure the wireless router. A computer with wired
Ethernet connection to the wireless router is required for this first-time configuration.
1. Set your computer to obtain an IP
address from wireless router: click
‘Start’ button (it should be located at
lower-left corner of your computer),
then click control panel. Double-click
Network and Internet Connections
icon, click Network Connections,
then double-click Local Area
Connection, Local Area Connection
Properties window will appear, and
then click ‘Properties’:

2. Select ‘Obtain an IP address
automatically’ and ‘Obtain DNS server
address automatically’, then click
‘OK’.
3. After the IP address setup is
complete, please click ‘start’ -> ‘run’ at
the bottom-lower corner of your
desktop, then input ‘cmd’ and click
‘OK’.

4. Input ‘ipconfig’, then press
‘Enter’ key. Please check the
IP address followed by
‘Default Gateway’ (In this
example, the IP address of
router is 192.168.2.1)
Please note that this value
may be different.
5. Start the web browser and input the
IP address of wireless router in
address bar, and the following
message should be shown. Please
input user name and password, then
click ‘OK’ to access web management
interface of wireless router.
Default user name: admin
Default password: 1234
6. Click ‘QuickSetup’
7. Select time
zone of the area
where you live,
then click ‘Next’.
HERE!
HERE!

8. Select a broadband type of the
Internet connection you’re using, then
click ‘Next’.
9. Please input the Internet connection
parameters, you should use the value
provided by your Internet service
provider.
Click ‘OK’ when you finish.
(The content of this page will vary
depends on the connection method
you selected in step 8)
10. Click ‘Apply’.
11. When you see this message, the
router will be ready with new settings
within 50 seconds.
12. Please use your computer to connect to any website on Internet, or start any
Internet application and see if they’re working properly.
For instructions of advanced settings and wireless network setup, please refer to user
manual in supplied document CD-ROM.