Digitus DA-70615 User manual

SAFETY PLUG
(1x USB TYPE-C™, 1x USB A)
Instruction Manual
DA-70615

2
Package Content
1x Main unit
1x User Manual
Energy Efficiency
Input:180-250V~, 50/60Hz,Max 0.25A
Output: 5.0V DC 2.8A, Max 14.0W
For Type A
Average active efficiency: 82.5 %
Efficiency at low load (10 %): 78.0 %
For Type C
Average active efficiency: 81.2 %
Efficiency at low load (10 %): 72.0 %
No-load power consumption: 0.09W
Connections
1. Turn power off before installation.
2. To connect the base as shown in Diagram A before installing
in into the mounting boxes, make sure there is no wire
exposed at the connection. Note the phases cannot be
ground trough to another safety wall outlet nearby. We
recommend installing the safety outlet at the end of the
row. (ATTENTION: the cross-sectional area of wire connect
power is at least 1.5mm^2 not exceed 2.5mm^2）
3. To fix the base by the screw or claw as Diagram B or
Diagram C, then put the frame onto the base.

3
3.1 FOR:

4
Important Notes
DO NOT OVERLOAD.
To install the product needed by a qualified electrician.
The symbol in manual.
For indoor use only
SMPS (switch mode power supply unit)
SMPS incorporating a Short-circuit-proof safety
isolating transformer (inherently or non-inherently)
Symbol for class II
E Protective earth
Protective earth

5
Warning
For your safety, please read the following cautions before
installing or using your device.
Do not open the device or attempt to repair it.
Use the device in a dry location, and avoid placing it
in a humid environment.
Do not submerge the device in liquid or attempt to clean it
with liquids or solvents. To clean the device, disconnect it
from the power outlet and use a damp towel.
This device should only be used indoors.
USB Charger Adaptor for IT-equipment: do not exceed
the total max output from both USB outputs.
Only use the device within the specified temperature
range for: 0 ~ 40°C
Do not let the indoor devices come into contact with liquids
During thunderstorms, there is a danger of lightning strike and
due to overvoltage damage to connected electrical appliances
Do not install the product during a thunderstorm
Disconnect the product from power source during a
thunderstorm
Keep the devices outside the reach of children,
since these components can be dangerous
Never try to repair the device by yourself. Repair and
maintenance work must be carried out by specialists
In case of problems contact our customer service
Dust, humidity and vapours as well as sharp cleaning
agents or solvents can damage the product.

6
Hereby Assmann Electronic GmbH, declares that the Declaration
of Conformity is part of the shipping content. If the Declaration
of Conformity is missing, you can request it by post under the
below mentioned manufacturer address.
www.assmann.com
Assmann Electronic GmbH
Auf dem Schüffel 3
58513 Lüdenscheid
Germany