Dimplex DCTFE97 User manual

For domestic household use only.
INSTRUCTION MANUAL
LED Tower Fan
Model: DCTFE97

IMPORTANT
THESE INSTRUCTIONS SHOULD BE READ CAREFULLY
AND RETAINED FOR FUTURE REFERENCE.
Note also the information presented on the appliance
CAUTION: FAILURE TO FOLLOW THESE INSTRUCTIONS MAY
CAUSE INJURY AND/OR DAMAGE AND MAY INVALIDATE
YOUR WARRANTY
Please read the operating instructions carefully before using your
fan for the rst time and keep them in a safe place.
WARNING – This appliance must not be used in a bathroom.
WARNING – Do not use this appliance in the immediate
surroundings of a bath, a shower or a swimming pool.
• Never immerse the appliance in water or other liquids.
• Operate this unit only on a rm, at surface.
• Do not place on soft, unstable or non-horizontal/angled
surfaces.
• Never operate the appliance if a cable or connector has been
damaged, after appliance malfunction or if the appliance was
dropped or is otherwise damaged.
• If the mains lead is damaged it must only be replaced by the
manufacturers service agent or a similarly qualied person in
order to avoid a hazard.
• Please ask a professional service agent to repair the product.
Improper repair may cause danger to users.
• Disconnect the appliance from mains power whenever it is not
in use, before relocating it, and before cleaning.
• Operate the appliance only at the voltage specied on the
rating label.
• Only connect the unit to a properly installed andeasily accessible
socket so that you can quickly disconnect the plug if necessary.
• Do not connect this product to the mains using an extension
lead.
• Thisfanisonly intendedforINDOORRESIDENTIALapplications.
This fan should not be used for commercial or industrial or
2

leisure applications or in small enclosed spaces.
• Never use the mains lead as a carrying strap or pulling lead.
• To avoid a re or electrocution hazard, NEVER put the cord
near heat registers, radiator, stoves or heaters.
• DO NOT cover cord with carpeting, throw rugs, runners, or
similar coverings.
• DO NOT route cord under furniture or appliances. Take care to
position the cord away from trac areas and where it will not
be a tripping hazard.
• DO NOT use the unit near windows or where water collects.
Rain and water collection may lead to a risk of re or electric
shock.
• Only operate this appliance with a minimum of 50cm clearance
all around i.e.away from walls, furniture and overhanging objects
such as curtains or a shelf.
• This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance
by a person responsible for their safety.
• Children should be supervised to ensure they do not play with
the appliance.
• To prevent spillage, empty the water tank before lifting or
relocating the appliance.
• WARNING: To avoid danger of suocation please remove all
packaging materials particularly plastic and EPS and keep
these away from vulnerable people, children and babies.
• NEVER drop or insert any object or ngers into any openings.
• Do not use the appliance in locations where paint, petrol or
other ammable liquids are used or stored.
• If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualied persons in
order to avoid a hazard.
• Do not use bug sprays or other ammable cleansers/vapour
sprays on or around the unit.
3

• Always switch o the unit and take the plug out of the socket:
• If you are not using the unit
• Before you clean or carry out maintenance on the unit
• If a fault occurs
• In the event of an electrical storm.
• Avoid electromagnetic interference. Keep the unit at least 1
metre away from electrical appliances such as televisions &
radios.
WARNING - KEEP BATTERIES OUT OF REACH OF CHILDREN
• Swallowing may lead to serious injury in as little as 2 hours or
death, due to chemical burns and potential perforation of the
oesophagus.
• If you suspect your child has swallowed or inserted a button
battery immediately call the 24-hour Poisons Information Centre
on 13 11 26 (in Australia) or 0800 764 766 (in New Zealand) for
fast, expert advice.
• Examine devices and make sure the battery compartment
is correctly secured, e.g. that the screw or other mechanical
fastener is tightened. Do not use if the compartment is not
secure.
• Dispose of used button batteries immediately and safely. Flat
batteries can still be dangerous.
4

Exposed to the
weather outdoors
Near water If the power cable
wires are frayed or cut
Where small children
may be left unattended
If an extension
lead may become
overloaded
Where there is risk
of re or close to
a naked ame
Where the power
cable may be
damaged
On a slope or
uneven surface
Where it may be
damaged by
chemicals
If there is a risk
of water falling on
the unit
Where there is a risk
of interference by
foreign objects
This product is not
made for DIY repair
5

Model no. DCTFE97
Colour
Black
Power supply
220-240V~, 50-60Hz
Rated power 45W
Speed settings 3
Modes 4
Timer 0-12
Air volume 1380m³/min
Oscillating Y
Controls Touch or remote
Cord storage Y
Noise level 58dB(A)
Weight (net) 3.4kg
Dimensions (w x d x h) 315 x 315 x 965mm
Specication
• For greater precision, please always refer to the rating label placed on the product.
6

Parts
Air outlet
Control panel LED Display panel
Base
Remote storage
Cord storage
Remote
7

Assembly
The base of the tower fan comes in two parts, which t around the oscillation base.
Both parts t easily together.
1. First attach the front half of the base, aligning the holes in the base with the
screw hole in the oscillation base and lead the power cord up the base.
2. Connect the back half of the base to the front half and secure with the plastic
screw nut (supplied) and twist is clockwise.
3. Plug into an appropriate power supply.
8

Operation
This tower fan can be operated by the control panel or remote control. Please refer to
the below diagrams for descriptions.
Mode button
Oscillation button
Speed button
Timer button
Indicator lights
• Oscialltion
• Normal mode
• Natural mode
• Sleep mode
• Child mode
Control Panel
LED Display
Timer & ambient
temperature display
Fan speed
Power On/O button
9

Normal:When this mode is selected, the fan will operate as normal, in the settings
selected.
Natural: This mode cycles through Low, Medium, High for 15 seconds each.
Sleep: The sleep mode varies depending on what speed the fan is working in at the
time of selection. Refer to the below examples:
Low Speed - the fan will work at this speed without change until it is
turned o (either manually or by the timer).
Medium speed - the fan will work at medium speed for 30 minutes, then
switch to low speed until it is turned o.
High Speed - the fan will work at high speed for 30 minutes, then switch
to medium speed for 30 minutes, and nally work in low speed be-fore
it is turned o.
Child: The timer sets at 3 hours and oscillation starts. The fan will work at high speed
for 15 minutes, before changing to medium speed for 15 minutes, and then nishing
in low speed until it automatically turns o. NOTE: The oscillation function can be
turned o manually and it won't interrupt the Child mode settings.
Operation
1. Place the fan on a at stable surface. Plug into an electrical outlet and press the
“Power On/O” button to turn the unit “On”. The current room temperature will
show on the LED display.
2. Adjust the fan speed by pressing the “Speed” button. There are three speeds -
Low, Medium & High and each press will cycle through the speed settings. The
speed setting will show on the LED display.
3. Press the “Mode” button to cycle through, Normal, Natural, Sleep & Child modes.
The indicator light of the chosen mode will illuminate on the LED display.
4. This unit has a 12 hour timer that can be set in 1 hour increments. Press the
“Timer” button until the desired time is shown on the LED display.
5. Press the “Oscillation” button to enable oscillation. Press again to disable.
Modes
10