IMPORTANT: THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE
Important Safety Advice
When using electrical appliances, basic
precautions should always be followed to reduce
the risk of re, electrical shock and injury to
persons, including the following:
If the appliance is damaged, check with the
supplier before installation and operation.
Do not use outdoors.
Do not use in the immediate surroundings of a
bath, shower or swimming pool.
Do not locate the appliance immediately below
a xed socket outlet or connection box.
The appliance carries the Warning
symbol DO NOT COVER, indicating
that it must not be covered.
This appliance can be used by children
aged from 8 years and above and persons with
reduced physical, sensory or mental capabilities
or lack of experience and knowledge if they
have been given supervision or instruction
concerning use of the appliance in a safe way
and understand the hazards involved. Children
shall not play with the appliance. Cleaning and
user maintenance shall not be made by Children
without supervision.
Children of less than 3 years should be kept
away unless continuously supervised. Children
aged from 3 years and less than 8 years shall
only switch on/off the appliance provided that
it has been placed or installed in its intended
normal operating position and they have been
given supervision or instruction concerning use
of the appliance in a safe way and understanding
the hazards involved. Children aged from 3
years and less than 8 years shall not plug in,
regulate and clean the appliance or perform
user maintenance.
Do not use this appliance in series with a
thermal control, a program controller, a timer
or any other device that switches on the heat
automatically, since a re risk exists when the
appliance is accidentally covered or displaced.
Ensure that furniture, curtains or other
combustible material are positioned no closer
than 1 metre from the appliance.
In the event of a fault unplug the appliance.
Unplug the appliance when not required for
long periods.
Although this appliance complies with safety
standards, we do not recommend its use on deep
pile carpets or on long hair type of rugs.
The appliance must be positioned so that the
plug is accessible.
If the supply cord is damaged it must be
replaced by the manufacturer or service agent
or a similarly qualied person in order to avoid
a hazard.
Keep the supply cord away from the front of
the appliance.
Warning: In order to avoid overheating, do not
cover the appliance. Do not place material or
garments on the appliance, or obstruct the air
circulation around the appliance, for instance
by curtains or furniture, as this could cause
overheating and a re risk.
Opti-Suite2Go²
Model: OPS2G2
UK
Warning: In order to avoid a hazard due to
inadvertent resetting of the thermal cut-out,
this appliance must not be supplied through an
external switching device, such as a timer, or
connected to a circuit that is regularly switched
on and off by the utility.
CAUTION - Some parts of this product can become
very hot and cause burns. Particular attention has
to be given where children and vulnerable people
are present.
The heater carries the Warning symbol, indicating
that it must not be covered. The replace must be
securely xed to the wall using the xing strap,
wall plug and screw supplied, see diagram 3 for
recommended position.
This instruction can be found at
WWW.DIMPLEX.CO.UK
General
Unpack the heater carefully and retain the packaging for possible
future use, in the event of moving or returning the re to your
supplier.
The re incorporates a ame effect, which can be used with or
without heating, so that the comforting effect may be enjoyed at
any time of the year. Using the ame effect on its own only requires
little electricity.
Before connecting the heater check that the supply voltage is the
same as that stated on the heater.
Please note: Used in an environment where background noise is
very low, it may be possible to hear a sound which is related to
the operation of the ame effect. This is normal and should not
be a cause for concern.
Electrical connection
WARNING – THIS APPLIANCE MUST BE EARTHED
This heater must be used on an AC ~ supply only and the voltage
marked on the heater must correspond to the supply voltage.
Before switching on, please read the safety warnings and operating
instructions.
Fixing - see Fig. 1&3.
The appliance should be securely xed by the nylon xing strap
provided. Step 1. screw the strap to the Opti-Suite2Go² as
illustrated in Fig.1. Next Drill holes using a 6mm drill bit into the
block wall, insert the plug into the wall and place the end of the
nylon strap over the plug and screw tightly to the wall. (Special
fastners are required for stud walls)
Manual Controls - see Fig. 2
Three switches provide a choice of heat setting. Each switch is
activated when the bottom half of the switch is pushed in.
Switch 1 Controls the electricity supply to the heater.
Note: This switch must be in the ON position for the
heater to operate with or without heat.
Switch 2 Provides 1kw heat output.
Switch 3 Provides 2kw output when used in conjunction with
switch 2
Continued
