Dinstar DAG1000-4S-V321 Operating and maintenance instructions

DAG1000-4S-V321
Quick Installation Manual

Packing List
1 X DAG1000-4S-V321 VoIP Adapter
1 X Power Adapter
1 X Telephone Line
1 X Ethernet Cable
1 X Quick Installation Guide
Product Appearance
Front

The gateway provides different LEDs:
PWR : power status
RUN : running Status
3-0 : indicate the status of FXS ports
LAN : LAN port connection status
WAN : WAN port connection status
Back
Back View and Interfaces:
DC12V :DC Jack

WAN: to connect to the IP network over DSL Modem
or Router or LANSwitch.
LAN:to connect to local network over LANSwitch or PC
0-3: FXS ports to connect to standard telephone set or
FAX Machine or a PBX.
RST: factory reset button, press 7S to restore factory
settings.
Hardware Connection
1. Connect 12VDC power adapter to the “DC 12V”jack.
2. Connect RJ-45 Ethernet cable to the WAN port and
the other end to a Router or LANSwitch.

* Router or Bridge work mode configurable on the web page
3. The device is start normally while the RUN LED
blinking slowly
Basic Operation
The gateway supports basic operation through
standard analog phone set. With an analog phone set,
the users could dial the feature codes to maintain
their gateway. The features codes lists as table 1-1:
Table 1-1: feature codes

Service Code
operation notice
*158#
Check LAN port IP address
*159#
Check WAN port IP address
*114#
Check port account
*115#
Check port group account
*160*1#
Enable Web access through WAN
port
*165*000000#
Restore to factory default values of
Web login Username/Password
and WAN/LAN port IP addresses
*166*000000#
Restore to default factory settings
*111#
Restart device
Gateway Configuration

1. Login the gateway
Open the browser on the computer and enter the
default IP address of the LAN port: 192.168.11.1.
Input default Username and Password:
“admin/admin”
2. Network Settings
Click on "Network - > Local Network”, input the WAN
port IP address and DNS server address, click “Save”
button to finish the configuration.

3. Configure SIP server
Click on "SIP Server”, input SIP server IP address or
domain name, SIP port and register interval in Primary

SIP server field, then click “Save”button to finish the
configuration.
4. Port Account configuration
Click on "Port -> Add", input SIP account details such

as Primary Display Name,Primary SIP User ID,Primary
Authenticate ID and Primary Authenticate Password

Click "Save" button to finish the configuration.
5. Restart the gateway
Restart the gateway for the configuration changes take
effect.
Additional Information
For detailed information of parameters, configuration
and troubleshooting description of DAG1000-4S,
please refer to the user manual or visit the website:
www.dinstar.com