Disney PIXAR MONSTERS UNIVERSITY MU-114 User manual

KIDdesigns warrants this product to be free from defects in
workmanship and materials, under normal use and conditions,
for a period of one year from the date of original -purchase.
Should service be required by reason of any defect or
malfunction, it is best to first return this product and all parts
thereof to the store where it was originally purchased. If you
need to send the product for service during the warranty period,
KIDdesigns will repair or, at its discretion, replace this product
without charge (except for a $6.00 charge for handling, packing,
return UPS/postage and insurance). This decision is subject
to verification of the defect or malfunction upon delivery of this
product to the Factory Service Center listed below. The product
must include proof of purchase, including date of purchase.
Before returning this product for service, please first replace
the batteries (if applicable) with fresh ones, as exhausted or
defective batteries are the most common cause of problems
encountered.
If service is still required:
1. Remove batteries (if applicable) and pack unit in a
well-padded, heavy corrugated box.
2. Enclose a photocopy of your sales receipt, credit card
statement, or other proof of the date of purchase.
3. Enclose a check or money order payable to the order of
KIDdesigns, for the sum of $6.00.
4. Send the unit prepaid to the Factory Service Center listed
below.
NOTE: This warranty is valid only if the product is used for the
purpose for which it was designed. It does not cover (i) products
which have been damaged by negligence, misuse or accident,
or which have been modified or repaired by unauthorized
persons; (ii) cracked or broken cabinets, or units damaged by
excessive heat; (iii) damage to tape cassettes (if applicable);
(iv) the cost of shipping this product to the Factory Service
Center and its return to the owner.
This warranty is valid only in the United States ofAmerica and
does not extend to owners of the product subsequent to the
original purchaser. Any applicable implied warranties are also
limited to one year, and KIDdesigns will not be liable for
consequential damages. (Some states do not allow limitations
on implied warranties or exclusion of consequential damages,
so these restrictions may not apply to you.) This warranty gives
you specific legal rights, and you may also have other rights
which vary from state to state.
Send unit to:
Consumer Repair Department
KIDdesigns, Inc.
1330 Goodyear Dr.
El Paso, TX 79936-6420
© Disney/Pixar
Visit the Pixar website at Pixar.com
Distributed by KIDdesigns, Inc. Rahway, NJ 07065-5024
eKids is a wholly owned subsidiary of KidDesigns, Inc,
1299 Main Street Rahway NJ 07065 Important Message to Customers
Thank you for purchasing one of Disney/Pixar’s many top-quality electronic products. We would appreciate it if you take
a few moments to read through these instructions. This will help you explain to the child the safe and proper way to use
this toy, and to help give it the long-lasting life that Disney/Pixar products are designed for.
Printed in China MU114-010813-A
MU-114 IB_front Printing color: Black Jan 9, 2013
Model MU-114
Limited One-Year Warranty
This device complies with Part 15 of the FCC rules. Operation
is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may
cause undesired operation.
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part
15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
WARNING: Changes or modifications to this unit not expressly
approved by the party responsible for compliance could void
the user's authority to operate the equipment.
This Class B digital apparatus complies with Canadian
ICES-003.
Cet appareil numérique de la classe B est conforme à la norme
NMB-003 du Canada.
FCC Information
ScareSchool Voice Changer

Record Button
Microphone
Getting Started
Turning Unit On
Recording Your Voice
Installing the Batteries
MU-114 IB_Back Printing color: Black Jan 9, 2013
Note: Batteries should always be installed by an adult.
Remove the Pull tab located by the battery
compartment and dispose of it properly.
쐃Use a Phillips screwdriver to open the battery
compartment door located on the back of the unit.
쐇Insert 3 AAA (R03) batteries into the unit with +
and - terminals as indicated in the compartment.
쐋Replace the compartment door and tighten the
screw with a Phillips screwdriver. Do not
over-tighten the screw.
• Pressing the Record Button, Play Button or SFX
Button will turn the unit on in the desired mode.
There is no OFF Button.
• To save batteries, after speech is played if there is
no further input, the unit will turn itself off.
• Press and hold the Record Button while speaking
into the Microphone to record up to 60 seconds of
speech (release to end recording).
• Press the Play Button to listen to playback.
• Press the Record Button again to record over a
previous recording with a new one.
You Should Know
For clear recording, keep the microphone
approximately two inches from your mouth. Avoid
shouting.
For the Best Possible Performance
• We recommend the use of alkaline batteries for longer life.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or
rechargeable (nickel-cadmium) batteries.
• Batteries are to be inserted with correct polarity.
• Remove exhausted batteries from the unit.
• Do not attempt to recharge non-rechargeable
batteries.
• The supply terminals are not to be short-circuited.
• Batteries should be removed if the item will not be
used for an extended period of time, such as a month
or longer, to prevent battery leakage or damage.
• Rechargeable batteries should only be charged under
adult supervision.
• Only batteries of the same or equivalent type as
recommended are to be used.
Play Button
Reset
pinhole
Effect Adjust (Hat)
Press the SFX Button (eyeball) to listen to speech in
the voice of Mike Wazowski.
It is important to keep the unit as dry and clean as
possible. You may clean the cabinet with a cloth or
sponge moistened with mild soap and water. Do not
attempt to use strong cleansers or solvents, as they
may cause damage.
Listening to Your Voice
Listening to Sound Effects
Maintenance
Questions or Comments
• Once you have recorded your voice, press the Play
Button to listen to playback.
• Slide the Voice Effect Switch to select the desired
voice effect:
Hi Makes recorded voice high pitched
Lo Makes recorded voice low pitched
Echo Makes recorded voice sound far
away
Robot Makes recorded voice sound
robotic
• Once a Voice Effect has been selected, turn the
Effect Adjust Knob (top of hat) to adjust
the effect. Experiment to find the sounds you like
best!
• For questions or comments regarding this or other
KIDdesigns products, please call our toll-free
number: 1-888-TOP-TOYS
Also visit our website: www.kiddesigns.com
If problems persist, please do not attempt to repair
unit; see warranty for factory service.
If the unit does not work, or the sound decreases notably
or becomes distorted, this may indicate that the batteries
are weak. Insert 3 new AAA (R03) batteries into the
unit.
If there is a sizable increase in static, it may be due to
the proximity of electric motors, fluorescent lights, power
lines, or other signal-disrupting objects. You may have
to change your location.
If the unit operation appears to be frozen or locked up,
you may need to reset the unit. To do so, insert the end
of a paper clip or similar into the Reset pinhole on the
back of the unit and gently press in.
If problems persist, DO NOT ATTEMPT TO REPAIR
THE UNIT. See the Warranty for factory services.
Troubleshooting
쐃
쐇

Voice Effect Switch
SFX Button