Displays2go IPPROEVRF User manual

Thank you for ordering 2-in-1 floor and table tablet kiosk stand. Let’s start setting it up!
Parts you will find
Aluminium Plate Bended tube Straight tube
Turn and put on floor Counter clockwise tightening the screw Counter clockwise tightening
using Hex end screwdriver the screw of another side
Step2 Straight Tube and Bended Tube Connection
Acrylic Cover Long Screw"a" 8pcs
Short Screw"b" 4pcs
Flat end Screw"c" 4pcs
Acrylic Corner Base
Screwdriver
Insert the bended tube Remember Counter clockwise tightening Ready for next step
feed the cable to the bended tube the screws of both sides using Hex end screwdriver
hexagon end 1pc Spline end 1pc Step3 Connect the Aluminium Plate to Step4 Connect 4pcs Acrylic corners to
the Bended Tube using 4pcs
Screw "b"
the Aluminium Plate using 4pcs Screw"a"
using Spline end screwdriver
Before assembling please prepare the extension cable if you want power routing
through stand. Cable not included Corner A at A position,
Corner B at B position,
Corner C at C position,
Step1 Base and Straight Tube Connection
Please remember to insert cable when install if need power routing.
Do not fully tighten all
screws!
Locate the pole as above picture 4pcs Flat end screws"c" to tighten
Need to adjust in next step.
The lock point face to the handle Base & Pole upside down and insert cable
User Manual

Step5 Add your Tablet PC and add the Acrylic cover using 4pcs Screw "a". Kensington Security Slot
Fully tighten all screws after installed all parts correctly. A Kensington Security Slot can be found on the stand at the bottom of bended tube and straight tube.
A Universal Computer Security Cable can be attached to this slot to add an extra theft deterrent.
When put the tablet, the Earphone jack should be
on C corner if you want to attach earphone or card reader.
VESA Hole
There are 4 VESA holes on the Aluminium plate
so that you can mount the enclosure to any stand
with VESA holes.
Install Complete
If need table stand just remove the straight pole Rotary Function Home Button Covered
Install the bended tube directly to base. The enclosure can rotate 360 degree. If you want the home button covered simplely switch
the Acrylic Cover one end to another.