Displays2go PROMXMN Series User manual

ASSEMBLY INSTRUCTIONS
PROMXMN Series - Promotional Counters
Remove the parts from the included carrying bag. The kit should include the folded plastic frame, wooden
countertop, two plastic shelves, two aluminum poles and plastic header.
STEP 1. Unfold the plastic frame and positioning it so the sides are at 90 degree angles to the front. Make sure that
metal shelf supports are placed on the inside and the small metal feet are at the bottom.
STEP 2. Attach the two shelves to the inside of the display. Hooks on the shelves connect to the support rails as
shown below.
- 1 -
STEP 3. After shelves are installed, rest the wooden countertop on top of the plastic frame. There are holes in the
countertop to accommodate the two included poles. Insert each pole into the two holes in the countertop.
Be sure that the Velcro® patches on the poles face front to hold the header.
V19.12

These poles connect the
countertop to the frame
and hold the header.
STEP 5. Attach the Velcro® header to the tops of the poles. The assembly is finished.
-2 -
STEP 4. Connect the poles to the plastic frame. Line up the holes in the poles with the screws in the plastic frame.
Insert the screws into the holes, and then push down on the poles to latch them firmly in place. See pictures below.
You may also need to push in on the plastic sides to make sure these pieces are securely connected.
NOTE: These instructions apply to promotional counters with and without vinyl graphics. (Vinyl graphics
will be pre-installed onto the PROMXMN counter)
If you have any questions regarding our products, please visit us at www.displays2go.com or contact D2G
customer service at 844-221-3388.
ASSEMBLY INSTRUCTIONS
PROMXMN Series - Promotional Counters