Displays2go DSTANDBK User manual

**1. One or more upper/lower tubing may have holes on both sides.
2. Make sure each tubing has at least one pair of 2 holes facing outward (see detail 2).
3. Arrange tubings with one pair holes (see detail 3a), then sort tubings with two pairs holes
(see detail 3b) to open places.
Open small box, lay out 4 long Tubings (C1, C2, D1, D2) on a flat surface. See picture below to
identify where each tubing goes to (upper or lower, left or right).
LEFT VIEW BACK VIEW
Lower Left Tubing
LEFT VIEW BACK VIEW
Upper Left Tubing
Lower Right Tubing
BACK VIEW RIGHT VIEW
Upper Right Tubing
BACK VIEW RIGHT VIEW
D1 D2
C2C1
2
2
3a 3b
A
A. Instructions 1
B. Metal Base 1
C1. Lower Round Tubing (Left) 1
C2. Lower Round Tubing (Right) 1
D1. Upper Round Tubing (Left) 1
D2. Upper Round Tubing (Right) 1
E. Tubing Connector 2
F. Pan Head Screw 12
CAUTION:
METAL BASE IS HEAVY! 2 PERSONS LIFT/MOVE
TO PREVENT ANY PHYSICAL INJURY.
*Hex Key for Part F can be found inside the TV Bracket box. (DUOPOLEBK)
B
C1 C2
F
E
D1
D2
PLEASE READ AND UNDERSTAND ALL INSTRUCTIONS BEFORE START THE ASSEMBLING.
FLAT BASE TV STAND
Parts
55 Broadcommon Road Bristol, RI 02809, USA Phone: [phone] (Int'l) Fax: [phone]
1
1

Fasten 4 Screws (Part F) with hex key.
Insert Tubing Connectors (Part E) into the
Fixed Lower Tubings. Hold it in place when
lining up holes. (Align with the top holes on
Lower Tubings)
Insert Upper Tubings (Part D) intoTubing
Connectors from above. The holes should
line up with the holes on Connectors.
Fasten 4 Screws (Part F) with hex key.
Ensure the 2 slot cutouts are facing
the same direction as other cutouts
on the Lower Tubings.
Insert Lower Tubing into the upright on
the Metal Base.
Ensure slot cutouts on uprights
and Lower Tubings align with
each other.
Holes at top of Lower Tubings should
face outward, to align with the holes on
Tubing Connectors. (See STEP 4)
Before assembling, remove packing materials.
Carefully place the Metal Base (Part B) on a
hard, flat ground.
All screws must be securely
tightened before using TV Stand.
Fix Lower Tubings by tightening 4 screws at
bottom of the TV Stand.
Fix Tubing Connector (Part E) on top of the
Lower Tubing.
Insert Upper Tubings with Connectors.
Insert 4 Screws (Part F) through Lower
Tubings into Connectors. Fasten screws
with hex key.
E
B
F
C1
C2
D1
D2
CAUTION: HEAVY METAL BASE CAN CAUSE MUSCLE STRAIN OR BACK INJURY.
FLAT BASE TV STAND
55 Broadcommon Road Bristol, RI 02809, USA Phone: [phone] (Int'l) Fax: [phone]
Still have questions? No worry. If you’re confused during any step of the way, just call the number located
at the bottom of the Instructions pages. Our friendly representative will be more than happy to help you.
2
3
4
5
2