MFB
On/Off
Slave speaker Master speaker
The speaker ID is now stored in the Bluetooth device’s memory.
For details about device discovery please refer to user guide of your bluetooth product to be paired.
Note :
When the speakers are not paired with a device for
3 minutes the paring mode is automatically turned off.
Please turn the speaker off and re-attempt paring
procedure from turning the speaker on (Step 1).
Re-pairing :
1.
2.
Press and hold MFB for more than 5 seconds until you hear the tones and
blue and red lights flash. You will hear tones twice at this time. (1st tone: when
the speakers turn on, 2nd tone : when the speakers are in pairing mode)
If the first step for repairing is successful please follow step 2 - 6 in pairing
procedure.
Pairing with Bluetooth Device :
Press and hold the multi-function button
(MFB) for more than 5 seconds until you
hear the tone twice and blue and red lights
are flashing, then release.
1.
Set your own Bluetooth device to discover
the DM-SP120 speaker by following
instruction guide of your bluetooth device.
2.
Select “DM-SP120” in the list of
discovered devices and confirm.
3.
When requested by the bluetooth device,
enter the passkey “0000” and confirm.
4. Select the music you want to listen to on
your Bluetooth device and enjoy the music.
7.
When the speakers are connected to a
paired device and are ready for use, the
blue indicator light flashes slowly(every
4 seconds) on the master speaker.
5.
Pressing On/Off button to turn on slave
speaker. The slave will be automatically
paired and connected to a master speaker.
6.
65
ENJOY THE MUSIC
Pairing with Another Bluetooth Device :
If you want to pair with another bluetooth device, first disconnect the speakers from paired bluetooth device you are using and then try pairing
with another bluetooth device following the pairing procedure.
If speakers are not connected to any device for about 30 minutes, master speaker turns off automatically. Slave speaker will be turned off
automatically in approximately 10 minutes after master speaker turns off. However, if you do not want to wait until speakers turn off
automatically, simply press On/Off button on the slave speaker and press and hold MFB to turn master speaker off.
“Auto-Connection” between speakers and the bluetooth enabled device like a mobile phone is available if the connected bluetooth
device is turned on again and speakers are within the communication range.
Disconnection :
In case the connected bluetooth device is turned off or the distance between speakers and connected bluetooth device is over the communi-
cation range (30 feet) recommended, speakers will be disconnected from bluetooth device paired. If the speakers lose their connection-target
you will hear warning ‘beep’ sound to search a device to connect.
Select the music you want to listen to on your bluetooth device.
Press On/Off button on slave speaker to turn on slave speaker to enjoy the stereo audio sound.
Adjust the volume by pressing the Volume Up/Down buttons.
Play, Stop, and Pause the music by pressing the multi-function button.
Play the music by pressing the multi-function button on the master speaker.
Select the music you want to listen by controlling FF( ), REW( ).
PAIRING
ENJOY THE MUSIC
PAIRING......continued
