Dolphin BC5083-120 Product manual

BC5083-120
DOLPHIN DISABLED ALARM
SYSTEM WITH PULL CHORD
Installation and Maintenance Guide
Please read carefully before use

BC5083-120 User Manual dolphinsolutions.co.uk
KIT CONTENTS
This kit comprises of everything required for the complete instalation of a BS8300 Compliant Emergency
Assistance Alarm, (excluding cables and fixings).
MAINS WIRING
› The wiring from the VoCALL Exchange, or from the VoCALL VCC5 Compact consists of a single pair; this does
not have to be fire rated, although this may be used, the link through to the pull cord is monitored and any open
circuit or short will be recorded as a fault on the VoCALL system
EXTRA LOW VOLTAGE (ELV) WIRING
› Always segregate low voltage wiring from the mains wiring.
› System requires minimum 2 core 0.4mm2 cable.
› All wall-mounting devices should be mounted onto a back box of the required depth.
OUT IN
VoCALL Unit Over Door Indicator
Over Door Indicator Cancel Unit
Cancel Unit Pull Cord Unit
+
-
+
-
VoCALL
Unit
Zone
Output
+
-
+
-
+
-
+
-
Over Door
Indicator
Cancel
Unit
Pull Cord Unit
IN
IN
OUT
OUT
10K
Open door indicator
Cancel Button
Part Code - CFEARSP
Ceiling Pull
part Code: CFEAPULL
WIRING GUIDE USING 2 CORE CABLE

BC5083-120 User Manual dolphinsolutions.co.uk
The upper cord pull should be located between
800mm & 1000mm above floor level.
The lower cord pull should be exactly 100mm above floor
level (remove excess cord)
The Over Door Indicator
provides an audibly and
visually signal to
indicate the area where
assistance is required.
VoCALL Unit
Ceiling Pull is surface mounted.
100mm
Knotthe cord to ensure the lowest
ring is100mm fromthe floor.
Cut off excess cord.
Screw the
two piece connctor
together
The Ceiling Pull should be
positioned so that its
readily assessable from
the WC, bath
(where applicable)
The Cancel Button
should be positioned so
that it is reachable from
the WC and a wheelchair.
INSTALLATION
› The Emergency Assist Alarm should be installed in accordance with the recommendations of BS8300 and to the
requirements of Building Regulations Approved Document M.
› The diagram below demonstrates a typical layout for installation in a disabled person toilet.
Note: Where pertinent other or alternative standards of design and installation should be adhered to.
› All system components are designed to be sited internally and positioned in locations where they are readily
accessible by the user.The area should be clean and dry and sound and light levels allow the status of all device
indicators and sounders to be seen and heard.
› Any likelihood of tampering or vandalism should also be taken into account at time of design.
OPERATION
To Place a Call Operate the Pull Cord. LED’s will illuminate on, Pull Cord Unit, Cancel Unit and Over Door
Indicator. An internal buzzer will also sound in the Over Door Indicator.
VoCALL Unit ...........
To Reset Call Press the Cancel Button.
MAINTENANCE
Weekly Clean plates with a non abrasive cleaning cloth and detergent, do not use harsh or solvent
based cleaners.
Monthly Test Call system by making and resetting a call.

BC5083-120 User Manual dolphinsolutions.co.uk
Dolphin Solutions
Southpoint, Compass Park, Bodiam, Robertsbridge TN32 5BS
Tel: [phone]
Fax: [phone]
www: dolphinsolutions.co.uk
[email protected].uk