DOM RONIS CoverK User manual

CoverK
Assembly

Drilling template
ASSEMBLY
Right hand door Left hand door
COVERK : Drilling template

Right hand door Left hand door
COVERK : Drilling template

Accessories
ASSEMBLY
ø3.8x39.7
C
D G
E F
ø4x26.6 ø4x14 Strike plate
Sticker Battery pack

Right door assembly
ASSEMBLY
ø2.5
1
A
2
19 + x mm
19 mm
x mm
AA
Section A-A

1
34
2
Right door
Right door assembly
ASSEMBLY
T20
T20
IMPORTANT:
Do not use an electric screwdriver
or drill to attach the battery holder.
Make sure the battery holder
does not plunge into the lock.

B
12
ø2.5
Le door assembly
ASSEMBLY
AA
19 + x mm
19 mm
x mm
Section A-A

Le door assembly
ASSEMBLY
1
34
2
Le door
T20
T20
IMPORTANT:
To fix the batteries container don’t
use electric screwdriver or drill.
Make sure the battery holder
does not plunge into the lock.

1
2
IMPORTANT
We suggest changing batteries
once every three years to ensure
their good condition. Batteries
can deteriorate over time and
damage the lock, especially in
hot environments.
Do not clean the locks with
cleaning products containing
hydrochloric acid, lye, or corrosive
components, especially on the
metallic parts.
WARNING
Do not mount ejectors
on door with force higher
than 15N.
Depending on door type
(le or right), assemble according
to the below images:
Verify that the batteries are in the
correct position (as indicated on
the battery holder).
21,8
21,8
70,6
70,6
Le door Right door

Important notes
ASSEMBLY
3
4
Verify that the latch works smoothly
in and out, without any friction with
the door frame.
Verify that the screws are not
fastened too tightly (<20kgf/cm2).
IMPORTANT
Maximum door thickness:
20mm.
The lock won’t work when
mounted on metal door.
To allow IP65 rate :
■ Maximum rugosity of the door :
Rt = 18 micrometers
(VDI 3400N°33)
■ Flatness of the assembly
area of the lock : 0.1mm
The Management / Master cards
are configured for a single
installation and are not compatible
with other installations.
TO BE TAKEN INTO ACCOUNT:
If you hear 4 beeps, there is not
enough clearance between the
lock’s latch and the counterlatch
(check the assembly).

Battery warnings
ASSEMBLY
If the CoverK continuously
beeps, the batteries are low.
The lock will no longer engage.
1. Unscrew the screw with the T20.
2. Release the battery holder.
3. Replace the old batteries.
4. Screw the battery holder back
into place.
Battery level
Depending on battery level,
the CoverK lock will emit sounds
regarding battery status, and
functionality may be limited.
Description of battery level sounds.
T20
....
Battery level Predetermined
acoustic signals
Acoustic signals of
the battery level
Open/Close
High Yes No Yes/Yes
Medium Yes Medium battery sound Yes/Yes
Low No Alert battery sound Yes/No
Sound Description
Medium battery (2 short beeps and 1 long beep)
When passing one card to the CoverK lock,
you will hear this signal.
Alert battery (5 short beeps)
When passing one card to the CoverK,
you will hear this signal. The lock will
remain open until batteries are replaced.