Dometic Go Power! GP-SB-PWM-30BT User manual

30A
6V -- 16Vdc
37.5A
- 40 to 60°C / - 40 to 140°F
99% N.C.
5.87 x 3.86 x 1.26 in; 149 x 98 x 32 mm
260 g / 9.2 oz
#8 AWG/10 mm2
5 years
Nominal System Voltage
Nominal Charge Current
Battery Voltage Range
Max Battery Charge Current
Max Solar Power
Display Consumption
Temp. Compensation
Operating Temperature
Humidity
Dimensions (H x W x D):
Weight
Maximum Wire Gauge:
Warranty
Protection
Battery/Solar Reverse Polarity, Battery/Solar Short Circuit,
Battery/Solar Reverse Current, Battery/Solar Over voltage up
to 50V, Over temperature, Over Current
600W
- 25mV/ºC
15mA
GP-SB-PWM-30BT
SINGLE BANK
BLUETOOTH®
SOLAR CONTROLLER
Quick Start Guide
Find tech tips, manuals and support at gpelectric.com
12V
SPECIFICATIONS
WARNINGS:
Icons Indicator
Scroll/Menu Selectors
Parameters Identifiers
Value Indicators
Value Units
Battery Type Indicator
No.
Descrip�on
No.
Descrip�on
14
25
6
3
NO. DESCRIPTION NO. DESCRIPTION
Scan for
full
manual
2
1
345
6

INSTALLATION
TOOLS
• Flathead Screwdriver (for wire terminals)
• Philips Screwdriver (for mounting screws)
ACCESSING SETTINGS
VIEWING CONTROLLER DISPLAY
The GP-SB-PWM-30BT includes an LCD of FSTN type with 4 mechanical buttons
that act as navigation keys to control the display. The GP-SB-PWM-30BT settings
can be accessed by entering menu number 2 as shown below.
BLUETOOTH®FEATURE
A Bluetooth® Low Energy module is integrated in the 30A model only.
For details on the data that can accessible/managed via Bluetooth®, please refer to
the GP-SB-PWM-10/30BT User Manual.
Three menus are implemented in the display: status, settings, and history. At power
up, the controller turns on within the status menu. The different menus can then be
accessed by pressing the Enter key as shown below.
INSTALLATION STEPS:
Install your solar array, and cover with opaque material until all wiring is complete.
Wiring should not exceed 25ft from the solar panels to the battery.
Wire the GP-SB-PWM-30BT according to the wiring diagram below. Be sure to torque
all screws based on the wire gauge after installation, as well as after 30-days.
The GP-SB-PWM-30BT is designed to be mounted flush against a wall, out of the way
but easily visible.
The GP-SB-PWM-30BT should be:
• Mounted as close to the battery bank as possible
• Mounted on a vertical surface to optimize cooling of the unit
• Indoors, protected from the weather
30 AMP SOLAR CONTROLLER
GP-SB-PWM-30-BT
30 AMP SOLAR CONTROLLER
GP-SB-PWM-30-BT