Donco 1210TT User manual

TO OBTAIN PARTS, PLEASE CONTACT:DONCO TRADING COMPANY - FORT WORTH, TEXAS
* Use of power tool to assemble this
product will invalidate any claim and
damage this product making unsafe !!!
* Please assemble on a clean soft
surface to avoid damage.
!Tools Required
(Not included)(Not included)
2: 0 h02: 0 h0
1- Follow the information on the warning label appearing on the upper bunk end structure and on the carton.
Do not remove warning label from bed.
2- Always use the recommended size mattress or mattress supporte, or both, to help prevent the likelihood of
entrapment or falls.
3- Surface of mattress must be at least 5 inchess below the upper edge of guardrails.
4- Do not allow children under 6 years of age to use the upper bunk.
5- Prohibit more than one person on upper bunk.
6- Periodically check and ensure that the guardrail, ladder and other components are in their proper position
free from damage, and that all connectors are tight.
7- Do not allow horseplay on or under the bed and prohibit jumping on the bed.
8- Always use the ladder for entering and leaving the upper bunk.
9- Do not use substitute parts. Contact distributor or dealer for replacement parts.
10- Use of a night light may provide added safety precaution for a child using the upper bunk.
11- If the bunk bed will be placed next to a wall, the guardrail that runs the full length of the bed should be
placed against the wall to prevent entrapment between the bed and the wall.
12- Always use guardrails on both long sides of the upper bunk.
13- The use of water or sleep flotation mattresses is prohibited.
14- Keep these instructions for future reference.
15- Strangulation Hazard - Never attach or hang items to any part of the bunk bed that are not designed for
use with the bed: for example, but not limited to, hooks, belts, and jump ropes, etc.
1210TT - TWIN TWIN BUNK BED

61
01
01
02
11
03
05
06
06
12
12
04
05
11
04
10
10
12
09
09
09
09
09
08
07
Part list: 1210TT - Twin Twin Bunk Bed
CERTIFICATION LABEL
00000
SEPTEMBER / 2018
DONCO TRADING CO.
MADE IN BRAZIL
MADE IN BRAZIL
CALIFORNIA 93120.7(d) COMPLIANT FOR
FORMALDEHYDE PHASE 2
PO # :
MFG DATE:
FOR RESIDENTIAL USE ONLY
NOT FOR COMMERCIAL USE
PRODUCT: TWINTWIN BUNK BED
MODEL #: 1210
MFG CODE # : 000
PO # : 00000
SEPTEMBER / 2018
MFG DATE:
DISTRIBUTED BY: DONCO TRADING CO.
FORT WORTH, TX 76140
WARNING
!
This bunk bed model has been tested
by an independent laboratory and is
in compliance with ASTM F-1427
Standard Consumer Safety
Specification For Bunk Beds and the
Government Code of Federal
Regulations 1213 and 1513.
California Proposition 65
This product can expose you to
chemicals, including formaldehyde
which is known to the
State of California to cause cancer.
For more information, go to
www.P65Warnings.ca.gov/furniture.
WARNING LABEL
DO NOT REMOVE!
CERTIFICATION LABEL
DO NOT REMOVE!
Please be careful when assembling this product due the parts are extremely heavy.
Also, please do not allow kids around when assembling this bed to avoid injuries!
CAUTION!
TO HELP PREVENT SERIOUS OR FATAL INJURIES FROM ENTRAPMENT OR FALLS:
DO NOT REMOVE THIS LABEL
WARNING
Prohibit horseplay on or under bed(s).
Prohibit more than one person on the upper bunk.
Use ladder for entering and leaving upper bunk.
STRANGULATION HAZARD - Never attach or
hang items to any part of the bunk bed that are
not designed for use with the bed; for example,
but not limited to, hooks, belts, and jump ropes.
Never allow a child under 6 years on upper bunk.
Only use mattress which is 74”-75” long and 37 ½” - 38 ½”
wide and maximum 9" high on upper and lower bunk.
Ensure thickness of mattress and foundation combined does
not exceed 9" and mattress is at least 5” below upper edge
of guardrails.
Use guardrails on both sides of upper bunk.
.
.
.
.
__

05
04
06
10
09

26
B
B
B
B
B
B
B
B
E
G
E
E
E
E
E
E
E
E
E
E
E
E
E
G
E
E
E
E
E
E
E
E
E
E
E
E
01
01
04
05
11
A
A
A
A
F
F
F
F
A
A
F
F
F
A
AF
!E
LSAT
``INSTALL SLAT KIT WITH SPACER
TAPE ON TOP(FACING UP)``
The first slats must be fixed at
3” from each headboard end.
!
G
G

26
A
A
A
A
D
D
F
F
F
F
F
F
A
A
D
D
F
F
F
F
B
B
B
B
B
B
B
B
E
E
E
E
E
E
E
E
E
E
E
E
E
E
E
E
E
E
E
E
E
E
E
E
E
E
03
02
05
06
06
04
11
F
A
AF
!E
LSAT
``INSTALL SLAT KIT WITH SPACER
TAPE ON TOP(FACING UP)``
The first slats must be fixed at
3” from each headboard end.
!

07
08
09
09
09
09
09
Please be careful when assembling this product
due the parts are extremely heavy.
Also, please do not allow kids around when assembling
this bed to avoid injuries!
CAUTION!

12
12
10
10
C
C
F
F
D
D
F
F
F
C
06

E x3
12