Doufit WB-02 User manual

Instruction Manual
WB-02 Weight Bench
!
* Please read the instruction manual carefully and follow it.
* Please keep the instruction manual for your later use.
* If you want to give this product to your friends, don't forget to bring them the instruction manual.
Step 3:
Attach the cushion(No.5). Screw six M8*70mm bolts(No.7) and six
M8 washers(No.8) by using the Allen wrench(No.9). Finally, tighten
three loose M8*16mm bolts.
Attention: If the bracket deviates when attached, the bolts may not
align the holes under the cushion. Please adjust the bracket to align
the holes.
Service
If you have any problem or question, please contact us via our service email.
We will try our best to solve it for you.
Our Email Address: [email protected]
Our Website: www.doufit.net
5
8
7

Precautions
Parts Listing
*The maximum load bearing is 800 Lbs.
*Keep children and pets away from the bench. This bench is designed for adults.
*Only one person can use the bench at a time.
*If you feel unwell during using the bench, please stop using it immediately and
consult your doctor for instructions before next use.
*It is recommended to use under guardianship.
*Please place the bench on a dry, flat and solid place to avoid falling.
*It is better to wear proper sportswear during exercise. Don’t wear the clothes
too loose to avoid drag.
*Before using, please warm up and stretch at first.
*Don’t put any obstacles or sharp items around the bench.
*Always check and tighten all screws of the bench before using it.
*Clean it with a wet cloth. Solvent cleaners are prohibited.
1 2
Assembly Method
1. Support x 1
2. Front foot pipe x 1 3. Rear foot pipe x 1 5. Cushion x 1
4. Bracket x 3
6. M8*16mm bolt x 9
7. M8*70mm bolt x 6 8. M8 washer x 6 9. Allen wrench x 1
Step 1:
Attach the front foot pipe(No.2) to the front of the support(No.1).
Attach the rear foot pipe(No.3). Screw six M8*16mm bolts(No.6) by
using the Allen wrench(No.9).
If any part is missing, distorted or broken when you receive the package, please
contact [email protected] with your order number, we will send the replacement
part to you as soon as possible.
Step 2:
Attach three brackets(No.4) under the support. Screw three
M8*16mm bolts. Don’t tighten these bolts now, or the step 4 will be
difficult to finish.
4
6
6
1
2
3
6
（Six of them are preassembled
on the foot pipes）