90 46 239 | 10.09-1 | Marketing Communications | LSL | ED | Printed in Germany | Chlorine-free – environmentally compatible | Subject to modifications | © 2009 Dräger Safety AG & Co. KGaA
Dräger X-plore®6000
Singlefilter Full Face Masks
ST-8425-2005
1
2
6
4
ST-7818-2006
Screw the Dräger X-plore Rd40 filter into the
mask body.
Open straps as far as possible. Direct the mask
towards the face.
... then both temple straps and ...
Fit harness over the head until the mask is in
position.
5
7
Tighten straps until the mask fits snug and
secure. First tighen both neck straps, ...
... tighten front strap if necessary. Negative pressure test: Seal respiratory filters
with your palm and breathe in until a negative
pressure (suction) is generated. Hold your
breath for a mo-ment. The negative pressure
should be maintained. If not, readjust the face
piece and adjust the straps. Repeat test until a
successful for check is met.
Preparation and filter attachment Donning the mask
Warning: Beards in the sealing area of the mask can
cause leaks. Always make sure the mask forms a tight
seal and the filter is attached prior to entering a
hazardous atmosphere.
This poster is not a replacement for reading and under-
standing the instructions for use for the subject mask
and respective filter cartridge, both of which must be
read before using either item! Failure to do so could
result in sickness or death!
For further assistance concerning proper use, ask your
supervisor or call your local Dräger organization at
+49 451 882-0 or +1 800 922 5518.
ST-7822-2006
ST-7859-2006
3
First insert chin into the chinpiece of the mask.
ST-7835-2006
ST-7843-2006
ST-7853-2006
ST-7861-2006
ST-7876-2006
8
Performing seal checks: before every use!
www.draeger.com
