Draper A10/EXP/F User manual

Unscrew barrel from pump head anti-clockwise (note no
barrel on Draper Stock No.16157).
Remove screw-cap from grease cartridge.
Push base of grease cartridge until grease is protruding
approx. 6mm out of the cartridge.
This is required to prevent air entering the pump unit.
INSTRUCTIONS
Stock Nos.16157, 16159, 16160 Part Nos.A10/EXP/F, A9/EXP/LS, A8/EXP/LS
2. ASSEMBLY
1. TECHNICAL DESCRIPTION
Manual for
Screw-on Grease Guns
Stock No..............................................16159 .............................................16160 .............................................16157
Part No............................................ A9/EXP/LS .......................................A8/EXP/LS.......................................A10/EXP/F
Pressure......................................10,000psi/690bar ............................5,000psi/345bar .............................7,500psi/517bar
Output ........................................ 0.5g per stroke.............................. 0.5g per stroke.............................. 0.8g per stroke
Cartridge type .......................400gm x large thread .................... 400g x large thread.................. 500 or 600g small thread

Screw steel barrel over cartridge, into pump head. Be
careful not to cross thread it. (Note: steel barrel is not
supplied or required for Draper Stock No.16157).
Pump grease gun to ensure grease is coming out of
outlet.
Screw cartridge firmly into pump head in a clockwise
rotation until it stops. Do not over tighten.
Screw outlet nozzle into main pump head in a clockwise
direction until tight. PTFE tape can be used for this joint
if required.
Pump handle to ensure grease is being expelled.
Grease gun is now ready for use.
Use above procedure to exchange grease cartridges. If changing grease types, be sure to clean out face of grease
cartridge mating face and use new grease to expel old grease before use. After initial assembly, there is no need to
remove the nozzle assembly.
DRAPER TOOLS LTD, HURSLEY ROAD, CHANDLER'S FORD, EASTLEIGH, HANTS. SO53 1YF. U.K. drapertools.com e-mail: [email protected]
PJKC0516