Drive Medical RS185001 User manual

shower commode
www.drivemedical.com
lifetime limited
warranty
Your Drive brand product is warranted to be free
of defects in materials and workmanship for the
lifetime of the original consumer purchaser.
This device was built to exacting standards and
carefully inspected prior to shipment. This Lifetime
Limited Warranty is an expression of our confi-
dence in the materials and workmanship of our
products and our assurance to the consumer of
years of dependable service.
In the event of a defect covered by this
warranty, we will, at our option, repair or replace
the device.
This warranty does not cover device failure
due to owner misuse or negligence, or normal
wear and tear. The warranty does not extend to
non-durable components, such as rubber
accessories, casters, and grips, which are subject
to normal wear and need periodic replacement.
If you have a question about your Drive device or
this warranty, please contact an authorized Drive
dealer.
© 2005 Medical Depot, Inc. All rights reserved.
Drive is a trademark of Medical Depot, Inc.
Port Washington N.Y. 11050 USA Made in China
EU Authorized Representative
Drive International, LLC
Globe Lane - Stockport
DUKINFIELD SK16 4RE, GB

assembly instructions
1. Place the seat, cushioned side down, on a flat
surface and assemble a seat hook to each corner
of the seat. Firmly tighten the screws to prevent
the hooks from sliding or turning.
Caution:
The “L” shaped hook must be located in the corner
indicated by the arrow above.
2. Caution:
Ensure that the seat stops are positioned as shown on
both seat rails to prevent the seat from sliding forward.
Each screw and nut should be tight enough to prevent
the stop from moving without deforming the end of
the seat rail, which would prevent easy folding of the
shower commode chair.
3. To install the seat, open the chair to its full width
and place the seat on the seat rails by the hooks
with the two “J” hooks on the seat rails with the
front hook located behind the seat stop. Lower the
other side of the seat until it rests on the seat rails.
4. To remove the seat, lift the seat rails about 1 inch
to narrow the chair, then lift the seat out of the
chair. The chair can now be folded completely.
Caution:
The curved edge of the seat must be at the rear of the
chair. Lift the seat rails about 1 inch, which allows the
remaining hooks to engage the seat rails, then push
down on the seat, which will open the chair to it’s full
width and lock the seat in place.
Caution:
Make certain that the front hooks are butted against
the back of the seat stops prevent the seat from sliding
forward.