Drive Medical 12021-4 User manual

bath bench
with back
item # 12021-4
www.drivemedical.com
lifetime limited
warranty
Your Drive brand product is warranted to be free
of defects in materials and workmanship for the
lifetime of the original consumer purchaser.
This device was built to exacting standards
and carefully inspected prior to shipment. This
Lifetime Limited Warranty is an expression of our
confidence in the materials and workmanship of
our products and our assurance to the consumer
of years of dependable service.
In the event of a defect covered by this
warranty, we will, at our option, repair or replace
the device.
This warranty does not cover device failure
due to owner misuse or negligence, or normal
wear and tear. The warranty does not extend to
non-durable components, such as rubber
accessories, casters, and grips, which are subject
to normal wear and need periodic replacement.
If you have a question about your Drive device or
this warranty, please contact an authorized Drive
dealer.
© 2006 Medical Depot, Inc. All rights reserved.
Drive is a trademark of Medical Depot, Inc.
Port Washington N.Y. 11050 USA Made in China

1. Place assembled Bath Bench upside down on
work surfaces shown in Figure 1.
2. Aach back support by sliding mounting tubes
through aluminum extrusion mounts and lock
into place with spring loaded push-pins.
Periodically check assembly for continued
tightness.
NEVER USE BATH SAFETY SEAT IF ANY
LOOSENESS IN THE ASSEMBLY IS NOTICED,
AS PERSONAL INJURY MAY RESULT. SIT.
DO NOT STAND ON THIS SEAT TO AVOID A
POSSIBLE DANGEROUS FALL.
CAUTION: Maximum weight limitation for this
product not to exceed 500 lbs.
NOTE: To maintain the beauty of the original
finish, clean with mild soap and rinse with warm
water. Wipe bath seat dry aer each use.
READ INSTRUCTIONS CAREFULLY BEFORE INSTALLING
assembly instructions
FIGURE 1
Height Adujustment
Snap Buon
Back
Support
Mounting
Tubes
Aluminum
Extrusion Mounts