Drive 13067 User manual

EU Authorized Representative
Drive International, LLC
Globe Lane - Stockport
DUKINFIELD SK16 4RE, GB
overbed table
item # 13003, 13067
lifetime limited
warranty
Your Drive brand product is warranted to be free
of defects in materials and workmanship for the
lifetime of the original consumer purchaser.
This device was built to exacting standards
and carefully inspected prior to shipment. This
Lifetime Limited Warranty is an expression of our
confidence in the materials and workmanship of
our products and our assurance to the consumer
of years of dependable service.
In the event of a defect covered by this
warranty, we will, at our option, repair or replace
the device.
This warranty does not cover device failure
due to owner misuse or negligence, or normal
wear and tear. The warranty does not extend to
non-durable components, such as rubber
accessories, casters, and grips, which are subject
to normal wear and need periodic replacement.
If you have a question about your Drive device or
this warranty, please contact an authorized Drive
dealer.
© 2006 Medical Depot, Inc. All rights reserved.
Drive is a trademark of Medical Depot, Inc.
Port Washington N.Y. 11050 USA Made in China

1. Table Top
2. Column Assembly
3. Trip Lever
4. 1/4-20 Bolt & Nut (1 each)
5. Bracket Top to Column
6. 1/4-12 Bolt (2)
7. Base
8. Casters with Brake
9. Casters without Brake
10. Bolt Sleeves (2)
11. Bolt Plate
12. 3/8-15 x 2” Bolts
13. Black Screw
14. Chrome Screw (Hex-Head Screw)
parts list
1. Open end of box. Slide contents out of
box. Lay on level surface. Remove base,
table top and hardware.
2. Insert column assembly (2) into top
brackets (5) as shown. Be sure the trip rod
(inside column) is fully inserted inside the
column. Align holes in column and top
bracket and install 2 bolts (6) & fasten.
3. Install trip lever (3) as shown, rounded side
facing table top. Be sure trip lever sits on
top of rod inside column. Align hole in trip
lever (3) with hole in top bracket (5) and
insert bolt & nut (4) to fasten the trip lever
& top bracket.
4. Place 2 bolts (12) through bolt plate (11) and
2 bolt sleeves (10). Place bolt assembly
into base to column.
5. Install casters (8, 9) as shown and replace
with chrome screw.
assembly instructions CAUTION
FOR SAFETY DO NOT REMOVE BLACK SCREW
ON COLUMN UNTIL TABLE IS FULLY
ASSEMBLED AND IN A STANDING UPRIGHT
POSITION. (CHROME SCREW HEX-HEAD ON
COLUMN IS NOT TO BE REMOVED)
DO NOT REMOVE BOTTOM SCREW
operating instructions
1. To raise top to desired height, apply light
pressure upward at any point under table.
2. To lower, squeeze trip lever (3) up towards
top and push down at column to desired
height. Do not put pressure on tabletop
end that is opposite the column. Column
assembly will lock upon release of trip lever.