Drive Ultra Light Plus User manual

1
Owner’s Assembly And Operating Manual
Ultra Light Plus, Semi Electric Bed
Competitor
Item # 15560

2
1. Remove contents from carton.
Assembly Instructions
2. Placebothendsofthesleepsurfaceontheirsideandaligntheangewiththereceptacleasshown.
3. Toattachtheheadandfootspring,pulltheblackknobawayfortheframeandslidethetwosides
 together.Thelockknobisspringloadedandwilllockintopositionwhenreleasedandthetwosections
 ofthebedareushtogether.
To disassemble the head and foot section, pull the black lock knob out and rotate the knob a quarter turn.
Thelockknobwillremainopentoallowtheheadsectiontoberemovedfromthefootsection.

3
Assembly Instructions Cont.
4. Securethesleepsurfacewiththecotterpinasshown.
5. Lockthecotterpinwiththeattachedclasp.Repeatontheoppositeside.

4
Assembly Instructions Cont.
6. Laythesleepsurfaceatontheground.
NOTE:Beforeinstallingmotor,plughandpendantcableintomotorasshown

5
Assembly Instructions Cont.
7. Connectthe9Vbattery(soldseparately)tothebatterycliponthemotor.Itisstoredintherecessunder
 themotorcover.Withthisbatteryinstalled,themotorcanbeoperatedtoreturnthesleepsurfacetothe
 horizontalpositionintheeventofapowerfailure.
8. To install motor, remove locking caps on top of the motor.

6
Assembly Instructions Cont.
There are two methods for the installation of
the motor
Method A
Themotorisinstalledonthebedframewhentheframeisstanding
on its side.
Installation instructions can be found on pages 8-9.
Method B
The motor is installed from underneath the bed frame
(horizontaltotheground)
Installation instructions can be found on pages 10-11.

7
Assembly Instructions Cont.
A2. Align the opening on the head end of the
 motorwiththeangeontheheadsectionof
 thebedandinserttheangeintothemotor
compartment.
Actuator Bar
A3. Withthepalmofyourhand,snapthemotor
 ushtotheactuatorbar.
A4. Align the opening on the foot end of the
 motorwiththeangeonthefootsectionof
 thebedandinserttheangeintothemotor
compartment.
Method A
Installation of the motor when bed frame is on its side
A1. Priortoinstallation,makesurethatthe2whitemotorblocksareintheretractedposition.
CORRECT INCORRECT

8
A5. Once in place, replace the motor covers to secure the motor.
A6.Besurethesleepsurfaceislockedsecurelytothehead/footboardbyasshown.
Assembly Instructions Cont.

9
A7. Repeat for the other side.
Assembly Instructions Cont.
End Method A

10
Method B
Installation of the motor from underneath the frame
B1.Besurethesleepsurfaceislockedsecurelytothehead/footboardbyasshown.
B2. Repeat for the other side.
Assembly Instructions Cont.