Drive 13069 User manual

overbed table
with plastic top
item #13069
lifetime limited
warranty
Your Drive branded product is warrantied to be free
of defects in materials and workmanship for the
lifetime of the product for the original consumer
purchaser.
This device was built to exacting standards and
carefully inspected prior to shipment. This Lifetime
Limited Warranty is an expression of our confidence
in the materials and workmanship of our products
and our assurance to the consumer of years of
dependable service.
This warranty does not cover device failure due to
owner misuse or negligence, or normal wear and tear.
The warranty does not extend to non-durable compo-
nents, such as rubber accessories, casters, and grips,
which are subject to normal wear and need periodic
replacement.
If you have a question about your Drive device or
this warranty, please contact an authorized Drive
dealer.

1. Remove contents from carton and lay top
board (1) upside down on flat surface. (Figure 1)
2. Take column assembly (2) and mount onto
bottom of top board (1) and secure with three
Allen bolts (6). (Figure 2)
assembly instructions
3. Screw castors (4) into base (3) making sure
the locking castors are opposite to the column.
(Figure 3)
4. Mount base (3) to column assembly (2) using
bolt plate and Allen bolts (5). (Figure 4)
figure 1
figure 2
figure 3
figure 4
castors #4
castors #4
castors #4
castors #4
castors #4
locking
bolt plate #5 bolt plate #5
allen bolts
for column
to top#6
allen bolts
for column
to top#6
allen bolts
#6
standard
allen bolts for base
to column #5
allen bolts for base to
column #5
allen bolts for base
to column #5
column #2
column #2
operating instructions
1. To raise top to desired height, apply light
pressure upward at any point under table top.
2. To lower, squeeze trip lever (7) up towards top
and push down at column to desired height.
Do not put pressure on tabletop end that is
opposite the column, column assembly will lock
upon release of trip lever (7).
table top #1
table top #1
base #3
base #3
trip lever #7