assembly instructions
READ INSTRUCTIONS CAREFULLY
BEFORE INSTALLING.
1. Place assembled Bath Bench upside down on
work surface.
2. Aach back support by sliding mounting
tubes through aluminum extrusion mounts
and lock into place with spring loaded
push-pins. An audible click will be heard
when pins are in place.
3. Turn Bath Bench over. Slide arms into mounts
and lock into place with spring loaded
push-pins.
Periodically check assembly for continued
tightness. Never use bath safety seat if any
looseness in the assembly is noticed, as personal
injury may result. Sit. Do not stand on this seat to
avoid dangerous fall.
The weight capacity is 300 LBS.
NOTE:
To maintain the beauty of the original finish, clean
with a mild soap and rinse with warm water.
Wipe bath seat dry aer each use.
lifetime limited
warranty
Your Drive brand product is warranted to be free
of defects in materials and workmanship for the
lifetime of the original consumer purchaser.
This device was built to exacting standards and
carefully inspected prior to shipment. This Lifetime
Limited Warranty is an expression of our confi-
dence in the materials and workmanship of our
products and our assurance to the consumer of
years of dependable service.
In the event of a defect covered by this
warranty, we will, at our option, repair or replace
the device.
This warranty does not cover device failure
due to owner misuse or negligence, or normal
wear and tear. The warranty does not extend to
non-durable components, such as rubber
accessories, casters, and grips, which are subject
to normal wear and need periodic replacement.
If you have a question about your Drive device or
this warranty, please contact an authorized Drive
dealer.
© 2006 Medical Depot, Inc. All rights reserved.
Drive is a trademark of Medical Depot, Inc.
Port Washington N.Y. 11050 USA Made in China
