DSE DK-CS4-HDS User manual

Document: DK-CS4-HDS 1M8
Page: 1
USER'S MANUAL DK-CS4-HDS Camera with concealment video recorder
DSE srl - Digital Surveillance Equipment - www.dse.eu
DK-CS4-HDS
WiFi concealment camera and
video recorder
Product description
DK-CS4-HDS is a video recorder equipped with an
integrated camera supplied on board in order to facilitate
insertion into objects. The card is protected by a plastic
container which makes it sturdy and easy to handle.
1. Target
2. Wifi antenna
3. Battery connector
4. RESET button
5. USB socket for PC or USB charger
6. Ignition switch
7. MicroSD card slot
Battery connection
The camera can operate on its own battery power only.
Different battery options are available with different
ranges. The standard battery, 1.5Ah, allows about 4 hours
of autonomy.
To use the device, connect the battery to the red plug.
Mains power supply
The DVR is also able to operate on mains power with a
220V / USB power supply such as RE-AL4USB or a USB
car adapter.
In this case, the USB cable is kept connected even during
operation. You can either leave the battery connected as a
backup or remove it.
Movie storage
The video files are stored on a micro SD card (not
supplied). The movies have Full HD 1920x1080 resolution
at 25 f / sec. And they are saved in MP4 format with H264
compression
It is possible to use micro SD cards of any brand up to
128 GB of capacity.
1 hour of recording occupies an average of 190MB so on a
32 GB SD card you can store over 160 hours of recording.
Obviously it is advisable to use motion detection
recording, where possible, in order to record only
meaningful images and not unnecessarily occupy memory
when no action takes place in front of the lens.
Once the memory has run out, the DVR will automatically
overwrite the oldest files if programmed in this way in the
configuration.
The duration of the individual files is also programmable in
the configuration.
Inserting the micro SD card
The first thing to do, if you want to make recordings, is to
insert the micro SD card in the appropriate slot in the DVR
(6)
It is possible to use micro SD cards with capacities up to
128 GB in CLASS 10 or higher.
A class 10 SD card has a write speed of 10 MB / s. Do not
use SD cards with lower speeds as they will lead to
malfunctions.
Pay attention to the direction of insertion of the SD card
which will slide into its seat only with the gold contacts
facing the USB socket.
No micro SD card is included in the package.
Charging the battery
Before using the device, it is advisable to fully charge the
battery. To do this, connect the USB port of the DVR to
the computer or to a USB charger with the supplied cable.
It is also possible to recharge the battery by connecting
the DVR to a USB mains power supply such as RE-AL4USB
(to be purchased separately).
The autonomous battery charger is also available as an
optional accessory, which allows you to recharge the
battery without being connected to the DVR.
Full charging takes several hours depending on the
battery type and initial charge state. It is recommended
that you comfortably let the charging complete overnight.
Next to the USB socket there is a red LED that turns on
during charging and turns off when charging is complete.
Assembly
DK-CS4-HDS is a concealment DVR. It is designed to be
positioned behind a masking surface in which a shooting
hole of at least 1 mm is made. in diameter.
Once the equipment is prepared, place the DVR behind
the masking surface. It is possible to hide the DVR in any
container, such as a pack of cigarettes, an ornament etc.
Here is an example of assembly, performed using the DK-
CSM magnetic accessory (not included)

Document: DK-CS4-HDS 1M8
Page: 2
USER'S MANUAL DK-CS4-HDS Camera with concealment video recorder
DSE srl - Digital Surveillance Equipment - www.dse.eu
The flat cable lens must be handled with care as damage
to the flat cable during use is not covered by warranty.
It is advisable not to hide the camera inside metal objects
because the wifi would be shielded and useless.
Turn on the device
DK-CS4-HDS is equipped with a power switch located next
to the USB (6). When turned on, the DVR does not emit
any visible signal except two internal LEDs. You need to
act on a smartphone and tablet with the HDSmartIPC app
to use it.
Download HDSmartIPC and setup
DK-CS4-HDS has been developed to be remotely
controlled via wifi with a mobile phone or tablet.
It is not necessary to have a wifi network to use DK-CS4-
HDS as the device is factory supplied in ACCCESS POINT
mode and it generates a wifi network itself to which you
can connect with Android / iOS portable devices.
First you need to download the HDSmartIPC application
from Google Play or Apple Store, available for free for
Android and iOS.
To use the program see the specific manual.
Once logged in with the app, you can intervene in the
configuration and connect the DVR to your wifi network.
All these operations are explained in the HDSmartIPC
application manual that you can download from the site.
Reset the DVR
If necessary, a RESET can be carried out by pressing the
reset button for 10 seconds with a deformed paperweight
clip or other thin object. After rebooting the DVR will
return to the factory Access Point mode.
Movie playback on PC
A computer and SD card reader (included) is required to
review and manage the files recorded by the DVR.
You have to turn off the DVR with the ON / OFF switch.
remove the micro SD card and insert it into a computer
SD card reader.
It is possible to copy the videos to the PC and play them
with any video player (VLC - VideoLan recommended).
ATTENTION: It is not possible to download files via the
USB cable of the DVR because this is used only for
recharging / powering the device.
Main technical features
Sensor CMOS
Maximum resolution FullHD 1080p (1920x1080)
Frame rate 30 f / sec
Video format MP4 (H264 compression)
Photo format JPG
Overlay Date time (not excludable)
Functions Continuous recording
Motion recording
Timer recording
Live viewing only
WiFi control Range 10 m.
Audio microphone Incorporated
Video storage About 640 hours on 128GB at
1080P
Operating
temperature -5 ° + 40 ° C
Memory MicroSD Class 10 or higher
Memory capacity 4..128 GB