
MV SERIES – MDVR for vehicles
Power connection
INSTALLATION MANUAL
Page:6
half, according to the following scheme
For the DVR to start up, it is necessary to apply the positive simultaneously to the red (IN+) and
time programming you can use the following scheme
If, on the other hand, you want the DVR to always be active or to turn on based on its
connecting the red cable to the battery positive and the yellow cable to the ACC output of the control unit
battery power.
As a rule, you connect the DVR so that it switches on and off automatically when switched on
half. The power cable to be connected to the vehicle's electrical panel is included to receive
DSE SRL – ITALY – WWW.DSE.EU
yellow (ACC) and the negative to the black wire (GND).
All DVRs in this range accept power from 8 to 36VDC to suit any
Machine Translated by Google