Duinotech XC4631 User manual

Raspberry Pi 3.5in Touchscreen with Stylus & Enclosure
XC4631
User Manual
Perfect for prototyping or a setting up a portable machine, the 3.5in touchscreen LCD display
requires minimal setup. Includes a handy stylus and protective case.
Specifications
LCD Type
TFT
LCD Interface
SPI
Touch Screen Typ e
Resistive
Touch Screen Controller
XPT2046
Colours
65536
Backlight
LED
Resolution
480 x 320 Pixel
What’s Included
1 x LCD To uc hscre e n
1x Stylus
1x Enclosure
Essential Accessories
XC9001 – Raspberry Pi 3B+
Installation
To setu p the s cree n, the dri vers wil l nee d to be downl oaded & i nstall ed usi ng the foll owing
commands in their respective order. You can either use the HDMI out on the Raspberry Pi or SSH for
the setup process.
git clone https://github.com/jaycar-electronics/XC4631
cd XC4631/XC4631
sudo chmod +x LCD35-show
sudo ./LCD35-show
Distributed by: TechBrands by Electus Distribution Pty. Ltd. 320 Victoria Rd, Rydalmere NSW 2116 Australia Ph: 1300 738 555
Int’l: [phone]
Fax: [phone]
www.techbrands.com
Made in China

Use the screws
provided to attach the
base plate firstly, to the
Raspberry Pi.
There are 4 such points.
Step 1

The sides lock into each other,
and start first with the any side
except side with cut-out for
connectors. We will add this in
the next step.
And then build the other sides.
Step 2

Now add the side with cut-out
for Pi connectors, and be careful
to watch the display cable if you
have already installed the
display.
Suggested approach is to install
the screen as last step.
Step 3

Step 4
As a last step, install the screen
on the Pi board, and aligning
with the GPIO connector
Final Build :