Tipro FREE+ User manual

guide the cables through
the main cable channel
pull out for RS232 Touch
pull out for analog Audio
jumper status for advanced interface settings
pull out for PS/2 & RS232 Controller
close the connection
cover and secure it by
pressing both snaps!
Before using
your FREE+,
set the
resolution of
your Video card
to 1024×768
and the refresh
rate to 60Hz!
and an external
FREE module if
present
you can also connect up to
2 other USB devices
connect the power supply
connect the USB controller
to the PC
open
the connection
cover
remove the
cable cover
if the cables exit at
the back remove the
back part of the
cable cover
put back the cable cover
and fix the 6 screws
provide sufficient
airflow around the
power supply *
*operating ambient temperature range is 0°C to 40°C
USB A are active if USB B is connectedNote:
SEC KBD is active if PS/2+RS232 is connected
then VGA
This is a Class A product. In a domestic environment this product may cause radio interference
in which case the user may be required to take adequate measures.
WARNING:
1
4
3
2
with
FREE+
Getting started

insert
Tipro CD follow the on-screen
directions
and calibrate the
touch-screen
run
ChangeMe
your FREE+ configuration will
be automatically detected
click on the
module
click on the key
to be defined
enter the
content for each
layer
follow directions and
finish the installation
select ChangeMe
installation from
the pop-up menu
select
ELO touch driver
installation
from the menu
FOLLOWING STEPS ARE NOT NEEDED IF:
- THE CONFIGURATION IS WITHOUT
PROGRAMMABLE KEYBOARD
- THE KEYBOARD IS ALREADY PROGRAMMED
NOT
and try your
new
configuration!
when finished,
program the
contents
3
6
5
4
12
Installing Touch Screen driver Installing ChangeMe programming utility