Dux Dynamic Headboard 120 User manual

DUX DYNAMIC
HEADBOARD 120
ASSEMBLY INSTRUCTIONS
DUX, DUXIANA and DUX Pascal-systems are registered
trademark owed by Dux Design AB 2012.
Printed 2021.02.01
dux.com

dux.com DUX, DUXIANA and DUX Pascal-systems are registered trademark owed by Dux Design AB 2012.
Printed 2021.02.01
1
HARDWARE TOOLS NEEDED
Allen key
(not included)
Spanner mm or
adjustable wrench
(not included)
1 U-shaped
tting – left
1 U-shaped
tting – right
4 Bolts
ASSEMBLING
I. RAISE THE HEAD-END
Raise the head-end to the maximum height.
II. REMOVE SCREWS
Remove the two hexagonal socket-head
screws in one corner.
Remove two pair of screws and mount
the tting at a time. If you remove all screws
at the same time the panel will come o.

DUX, DUXIANA and DUX Pascal-systems are registered trademark owed by Dux Design AB 2012.
Printed 2021.02.01
dux.com2
III. MOUNT THE U-SHAPED FITTING
Using the new bolts supplied
fasten one U-shaped tting as shown.
Repeat these steps on
the other side of the bed.
IV. MOUNT THE HEADBOARD
Mount the headboard to the proles
and tighten. Be sure to tighten all screws
including those on the ttings.