Dux FLEX User manual

DUX, DUXIANA and DUX Pascal-systems are registered trademark owed by Dux Design AB 2012.
Printed 2019.10.01
dux.com
2
FLEX HEADBOARD
ASSEMBLY INSTRUCTIONS
DUX, DUXIANA and DUX Pascal-systems are registered
trademark owed by Dux Design AB 2012.
Printed 2021.02.01
dux.com

dux.com DUX, DUXIANA and DUX Pascal-systems are registered trademark owed by Dux Design AB 2012.
Printed 2021.02.01
1
HARDWARE TOOLS NEEDED
Allen key mm
(included)
Spanner mm or
adjustable wrench
(not included)
2 Bolts
2 Square washers 2 Washers
2 Nuts
1 Screws
ASSEMBLING
I. MOUNT THE BARS ON THE BED
Mount the two bars from the
frame on the bed using
two bolts, washers and nuts.
II. PUT THE HEADBOARD IN PLACE
Put the headboard in place and tighten
the screws in the desired position.
2 Bolts
2 Square washers
2 Nuts
2 Washers
1 Screws

DUX, DUXIANA and DUX Pascal-systems are registered trademark owed by Dux Design AB 2012.
Printed 2021.02.01
z2
III. FINE ADJUSTMENT
There is a possibility to make a ne
adjustment of the headboard height.
Be sure to fasten the screws after adjusting.
IV. ADJUST THE ANGLE
Press the button to adjust the angle of
the back cushion.