Dynamic 301000 User manual

SQUAT STAND
301000
3/8" HEX KEY WRENCH (SUPPLIED)
Model:
Tools Required:
For installation and assembly questions please contact
DYNAMIC technical services at 844-678-7447
See the complete line of products at MYDYNAMICFITNESS.COM
Twitter@DynamicFandS
Facebook@DynamicfitnessandStrength
Instagram@Dynamic_fitness_and_strength

STEP TWO:
INSTALL TWO SIDE UPRIGHTS BETWEEN TWO SIDE PLATESAS
SHOWN USING (4X) MATING BOLTS PER SIDE. MAKE SURE
DYNAMIC LABEL IS FACING OUTWARDS ON BOTH UPRIGHTS.
KEEP BOLTS SLIGHTLY LOOSE.
STEP ONE:
INSTALL CENTER CROSSBAR INBETWEEN TWO BASE TUBES
USING (4X) MATING BOLTS AS SHOWN.
KEEP BOLTS SLIGHTLY LOOSE.
CUSTOMER SERVICE: 844-678-7447 WWW.MYDYNAMICFITNESS.COM

STEP FOUR:
MAKE SURE RACK IS SITTING FLUSH ON FLOOR, THEN TIGHTEN
ALL HARDWARE ON RACK.
INSTALL J-CUPS AT DESIRED LOCATION.
STEP THREE:
INSTALL PULL UP BAR AT DESIRED LOCATION AT TOP OF RACK
USING (4X) MATING BOLTS.
KEEP BOLTS SLIGHTLY LOOSE.
CUSTOMER SERVICE: 844-678-7447 WWW.MYDYNAMICFITNESS.COM