Eagle T412E Programming manual

PORTABLE SAFE
T412E
Usage and Maintenance Instructions

2
Usage and Maintenance Instructions
INTRODUCTION
Thank you for deciding to purchase the Portable Safe by Eagle.
BEFORE USE
Carefully remove all packaging. Avoid using any knives of other sharp instruments as this may damage
the item. Check the product for any visible damage If you see any damage or suspect a fault, do not use
your product, but contact your supplier for support.
CLEANING
Clean your Portable Safe using a mild detergent with a slightly damp, soft cloth only. Only use a mild
detergent or disinfectant; never use an abrasive cleaner.
CARE & MAINTENANCE
Please make a safety check of the product at regular intervals or if you have any concerns.
REISSUE
If you reissue or are about to reissue this product, please thoroughly check all components for their
safety.
If in any doubt, lease do not issue or use, but immediately contact your su lier for service su ort.
IMPORTANT INFORMATION
The information given in this instruction booklet must not be taken as forming part of or establishing any
contractual or other commitment by Electrovision Ltd or its agents or its subsidiaries and no warranty or
representation concerning the information is given.
Please exercise common sense and do not take any unnecessary risks when using this product; as the
user you must accept liability for safety when using the product.
Please do not hesitate to contact the person who issued this product to you or the manufacturer (detailed
below) if you have any queries concerning the assembly/use of your product.
INSTRUCTIONS
Opening the portab e safe:
Default Factory Code: 0-0-0
otate the dials to the correct code.
Lift the lid.
Add or remove valuables.
Close the lid.
otate dials to incorrect code to lock.
See next page for how to set a new combination
IMPO TANT
We do-not recommend simple combinations such as 0-0-0 or 5-5-5. It is
recommended that the dials are rotated weekly to keep them moving
freely.

3
Usage and Maintenance Instructions
Set a new combination:
PLEASE NOTE: THE CODE CANNOT BE RESET UNLESS THE SAFE IS
OPENED. THERE IS NO OVERIDE.
Open the safe (as page 2).
emove the bottom lining from the inside.
Push the reset lever from position B to position A (See Diagram 1)
otate the dials to your desired combination.
eturn the lever to position A.
eturn the bottom lining to the inside of the safe.
Close the lid and rotate the dials to lock the safe.
Diagram 1
Locking Cab e:
otate the dials to open the safe.
Loosen the looped cable.
Wrap cable around stationary object.
Fit end (A) through loop (B). (See Diagram 2)
Place end A into the cable lock slot on the left edge of the safe.
Close the lid and lock the safe.
Diagram 2

4
Usage and Maintenance Instructions
SERVICE WARRANTY
Electrovision guarantees the product free from defects in materials and workmanship for a period of
twelve months.
The product you buy may sometimes differ slightly from illustrations. This warranty is in addition to, and
does not affect, your statutory rights.
Our guarantee is administered by our retailers.
If your product arrives damaged, you must contact the retailer from whom you bought it. The retailer's
contact details will be on the invoice that arrived with the product, or on the e-mail you received when
you placed the order. Do not contact Electrovision, only your retailer can arrange a replacement.
If your product fails within the guarantee period, and needs to be repaired or replaced, you must contact
the retailer from whom you bought it.
The retailer's contact details will be on the invoice that arrived with the product, or on the e-mail you
received when you placed the order.
If you have just received your product and require technical help in using it, please call our Help Desk
on [phone]
Electrovision Ltd.,
Lancots Lane, Sutton,
St. Helens, Merseyside.
WA9 3EX
Website: www.electrovision.co.uk