Early Childhood Resources ELR-0636 User manual

E
B
F
F
F
F
E
E
E
E
Mount Laurel,NJ 08054 USA
www.ecr4kids.com
Model No. ELR-0636
25-Tray Storage Cabinet
TIP！
DO NOT FULLY
TIGHTEN SCREWS
UNTIL ALL SCREWS
HAVE BEEN LOOSELY
POSITIONED。
!
WARNING:
- Adult Assembly Required. Two
adults recommended.
- Contains small parts, sharp points
and edges.
- Do not stand, sit, kneel, climb, lean
or pull on unit for support.
- Never leave children unattended.
- Do not place unit near high heat or
moisture.
-Adult Supervision Recommended.
Left Side Panel
Right Side Panel
Top Shelf
Middle Shelf(1)
Middle Shelf(3)
Bottom Shelf
Back Panel(5)
Divider(4)
LargeHexScrew(20)
Metal Dowels(8)
Hex Key Tool
WheelCasters(4)
CasterScrews(16)
Cams(8)
PARTS LIST
B
D
E
F
C2
A1
A2
C1
G
H
I
J
K
L
B
B
C2
D
E
F
C2
C2
C1
A1
F
F
F
D
A2
A1
A2
BEFORE ASSEMBLING,
MAKE SURE THERE
ARE NO
MISSING PARTS.
B
H
Ｘ８
H
1
Attach the Dividers to the Top Shelf
B
F
F
F
F
L
Ｘ８
L
1A. Place the Top Shelf(B) top-down on a carpet or protected surface.
Insert 8 Metal Dowels(H) into the plastic plugs located underneath
the Top Shelf(B). Tighten with a Phillips Head Screwdriver.
1B. Insert 2 Cams(L) into the large holes in each of the Dividers(F).
Make sure the arrows on Cams(L) point toward the holes in the closest
edge.
1C. Position the Dividers(F) so Metal Dowels(H) attached to Top Panel(B)
enter the holes in the top edge. Turn Cams(L) with a Phillips Screwdriver
until locked onto the Metal Dowels(H).
2
Insert the Back Panels
2. Slide the Back Panels(E) into the grooves between the Dividers(F)
until fully inserted into the slot as shown.
B
EF
C2
C2
C2
C1
3
Insert the Middle Shelves
3A. Insert a Middle
Shelf(C2) as shown
onto the Dividers(F)
until fully inserted.
3B. Insert a Middle
Shelf(C1) as shown
onto the Dividers(F)
at the center slots
until fully inserted.
3C. Insert 2 Middle
Shelves(C2) onto the
Dividers(F) as shown
until fully inserted.
4
Attach the Divider Section to
the Base
4.Attach the Base
to the Divider
Section(F,E,C1,C2)
using 8 Large Hex
Screws(G).Tighten
with the Hex Key
Tool(I).
5
Attach the Wheel Casters
5. Beginning with the holes on the inside of the Wheel Caster(J) mount
plate (opposite the kickplate on Base(D)), attach the 4 Wheel Casters(J)
using 16 Caster Screws(K). Tighten with a Phillips Screwdriver.
G
Ｘ８
G
D
B
E
F
F
F
F
C2
C2
C2
C1
B
D
F
C2
C2
C2
C1
J
K
Ｘ４
Ｘ１６
Version: ELR-0636.D.2010.01.03
JK
Attach
First
Mount
Plate
Caster
Screw

6
Attach the Side Panels
G
Ｘ１２
6.Attach the Left Side (A1) and Right Side Panels (A2) to the Middle
Shelf (C1), Top Shelf (B) & Bottom Shelf (D) with 12 Large Hex
Screws (H), using 6 per side. Tighten using the Hex Key Tool (I).
7
You are done!
!
CAUTION:
- Do not allow children to climb on shelves.
- Do not use as a ladder, seat or cart.
“Early Childhood Resources® guarantees the quality
of all of our products. You can trust the quality and
safety of our furniture and materials, along with the
peace of mind that our products are made to last. If
for any reason, you are not satisfied with the quality
and workmanship of our products, we will replace the
item or refund the sale.”
We appreciate your purchase of the 25-Tray Storage
Cabinet. Early Childhood Resources® has made every effort to
supply a quality product, that with proper use and care,
will bring you many years of trouble free use!
Clean wood with a damp cloth or sponge using warm water
and mild soap. Wipe dry.
Do not place near heat, moisture or vaporizer which may
cause wood to warp and peel.
Check for loose or worn parts periodically and tighten or
replace as necessary.
Care and Cleaning
B
D
FFFF
C2
C1
G
A1
A2
C2
C2
D
Purchase Order Number:
Record the Purchase Order Number here. Information is
located on a label enclosed, and on the shipping carton.
Place label and this sheet in an accessible place.
Model Number: ELR-0636
Version: ELR-0636.D.2010.01.03