EARNSHAW ES-8046 User manual

B) WINDING THE MAINSPRING
Automatic winding watch can be hand wound by turning the crown in it’s normal crown position.
Wind 15-20 times and it will start tomove naturally after shaking slightly.
C) TIME SETTING
1. Pull the crown to position2.
2. Turn the crown to set Hourand Minute Hands.
3. Push the crown backto position 1.
D) QUICK CHANGE CORRECT OR FOR DAY (Push “A” at 4 o’clock position)
1. Pull the crown to position 2.
2. Pressing pusher “A” moves the day display forward by one day.
3. You must not use this quick change corrector between 11:30 p.m. and 5:30 a.m. because the automatic change mechanism is in operation
betweenthese times.
A) DISPLAY
Hour Hand
Second Hand
Day Indicator
1 2
AUTOMATIC 3 HANDS MULTIFUNCTION
(RETROGRADE DAY, RETROGRADE DATE AND OPEN HEART)
Minute Hand
Date Indicator
Pusher“A”Pusher “B”
Page 1 of 2

A) DISPLAY
Hour Hand
Second Hand
Day Indicator
1 2
AUTOMATIC 3 HANDS MULTIFUNCTION
(RETROGRADE DAY, RETROGRADE DATE AND OPEN HEART)
Minute Hand
Date Indicator
Pusher“A”Pusher “B”
E) QUICK CHANGE CORRECT OR FOR DATE (Push “B” at 8 o’clock position)
1. Pull the crown to position 2.
2. Pressing pusher “B” moves the date forward by one day. You mustnot use this quick change corrector between 11:30 p.m. and 5:30 a.m.
because the automatic change mechanism is in operation between these times.
F) SET DATE & DAY
1. Pull the crown to position 2.
2. Continue rotating handsuntil 6:00a.m. Use the quick-change correctors to set the day (pusher “A”) and date (pusher “B”)then use the
crown toturn the hands forwards until the current date is reached. You have now set the correct date and day.
NOTE:
This watch MUSTbeworn forat least 8 (Eight) hours each day to ensure it is fully wound.
An automatic watch will only wind when thewatch is on your wrist and your arm moves.
Winding thewatch by the crown will put power on the spring but not enough to allow thewatch to function fully.
If your watch stops overnight orloses time it means it is not being fully wound.
Page 2 of 2