EARNSHAW London User manual

Vol.1.29 EN
Congratulations
on your purchase of this nely
crafted Earnshaw Timepiece.
You are now the owner of a
timepiece that draws its roots from
the renowned English horologist,
clock and watch maker
Thomas Earnshaw
1749 - 1829

A) DISPLAY
CHRONOGRAPH
WATCH
This watch is equipped with
a quartz powered
chronograph movement.
Besides the normal time read out,
this movement enables split timing
micro measurements of time at the
push of a button, which can be
utilized in a variety of applications.
For more details on operating this
timepiece please refer to the enclosed
booklet or visit :
IM.THOMAS-EARNSHAW.COM
0 1
(1st click) (2nd click)
CLOSED:
PUSHED BACK
AND WATER RESISTANT
OPENED:
NOT SECURED FOR
WATER RESISTANCE
2
1
Stopwatch
1/20 Second Hand
Chronograph
Second
Hand
Chronograph
Minute Hand
Minute
Hand
Crown
Date
Hour Hand
Second
Hand
Push
Button
A
Push
Button
B

23
B) HOW TO SET THE
TIME
1. Pull the crown to position
[2]-(2nd click).
2. Turn the crown clockwise to set the
correct time.
3. Push the crown in.
0
12
0 2
1
0
* If the date is set between the hours of
around 9:00 P.M. and 3:00 A.M., the
date may not change on the following
day.
C) HOW TO SET THE
DATE
1. Pull the crown to position
[1]-(1st click).
2. Turn the crown to set the correct
date.
3. Push the crown in.

4
D) STOPWATCH
FUNCTION
• This chronograph is able to measure
and display time in 1/20 second
united up to maximum of 59min
59sec.
• The chronograph 1/20 second hand
moves continuously for 30 seconds
after starting, and then stops at Zero
position.
STANDARD
MEASUREMENT
5
ACCUMULATED
ELAPSED TIME
MEASUREMENT
STOPRESET
START STOP RESTART
Restart and stop of the stopwatch can
be repeated by pressing the button
A .
START STOP RESET

7
6
E) CHRONOGRAPH RESET
(incl. after replacing battery)
This procedure should be performed
when the chronograph second hand
does not return to the Zero position.
1. Pull the crown out to the [2]-(2nd
click).
2. Press the button “A” once to set the
chronograph second hand to the Zero
position.
3. Press the button “B” once to set the
chronograph 1/20 second hand to the
Zero position.
* The chronograph hands can be
advanced rapidly by continuously
pressing button “A” or “B”.
4. Once the chronograph hands are set
at Zero position, readjust the normal
hour and minute hands to the correct
time and return the crown to its
normal position.
Stopwatch
Second Hand
Zero Positions
Stopwatch
1/20 Second Hand
Zero Position (0.0 Sec)

8 9
WATER RESISTANCE
The water resistance indicated on
your timepiece serves only as a
guide. Actual water resistance may
vary depending on a number of
important factors including
temperature, water salinity, and
actual use under water.
The water resistance of your
timepiece may eventually be
compromised over time with general
wear and tear and the use of your
watch under adverse conditions.
Always remember to employ the
screw down crown (if available) to
maintain the water resistance of your
timepiece. Warranty may be voided if
the screw down crown has not been
properly employed.
Reset
stopwatch
second hand
to zero
Reset 1/20
stopwatch
second hand
to zero
0
12 2 2
Readjust
the hour
and minute
hands

Note that you should NEVER wear
your watch in a jacuzzi, hot shower or
steam room where steam may enter
the case despite the watertight seals
used to protect your watch.
The steam may cause condensation
inside your watch, which may affect
and damage the inner workings of
your watch – which would also not be
covered by the warranty.
10