East West Furniture bus-blk-lc User manual

BUCKLAND COUNTER HEIGHT CHAIR WITH FAUX LEATHER UPHOLSTERED SEAT
- 1 -
ASSEMBLY INSTRUCTIONS
Description
Di
mension
:
BUCKLAND COUNTER HEIGHT CHAIR WITH FAUX LEATHER UPHOLSTERED SEAT
: 7.5”Wx20.5”Dx42”H
Cube Size : 44”x 8.6” x 0.4” NW: 37.4 LBS
GW: 4 .8 LBS

BUCKLAND COUNTER HEIGHT CHAIR WITH FAUX LEATHER UPHOLSTERED SEAT
- 2 -
BEFORE A
SSEM
B
LY
Thank you for purchasing this quality product. This product has been designed for easy assembly and constructed for durability. Please take
the time to read and follow the assembly instructions carefully.
Be sure to check all packing material carefully for small parts which may have come loose inside the carton during shipment. Please separate,
identify, and count all parts and metal hardware. Compare with part list to be sure all parts are present.
If hardware is missing or you have difficulty assembling this product, please call for us.
IMPORTANT NOTE:
- Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from being scratched.
- Remove all wrapping material, including staples & packing straps before you start to assemble.
- DO NOT tighten all screws and bolts until completely assembled.
- Keep all hardware parts out of reach of children.
PART
LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing, please make sure you have the following
parts:
NO
Description
Q
ty
Sketch
NO
Description
Q
ty
Sketch
A Chair back 1 B Seat Frame 1
C-R
Front Leg
1
D-R
Side stretcher
1
C-L 1 D-L
1
E Front Stretcher 1
ASSEMBLY TOOLS REQUIRED
NOT INCLUDED

BUCKLAND COUNTER HEIGHT CHAIR WITH FAUX LEATHER UPHOLSTERED SEAT
- 3 -
HARDWARE LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing, please make sure you have all of the
following hardware:
NO
Description
Q
ty
Sketch
NO
Description
Q
ty
Sketch
1
Long bolt
(M6x80mm)
4
2
Medium bolt
(M6x60mm)
4
3
Short bolt
(M6x40mm)
2
4
Lock Washer
(Ф6.5x9)
10
5
Flat Washer
(Ф6.5x19)
10
6
Allen Key
(4mm)
1
7
Screw
(M4x40mm)
6
STEP 1
Attach frame (B) to the back (A) by using bolts (3) and (1) and washers (4) and (5). Tighten with Allen Key (6).
Note: DO NOT tighten any of the bolts, until the chair is assembled, then put on a flat level surface to make sure
the chair is level and then tighten the bolts.
X4
X2

BUCKLAND COUNTER HEIGHT CHAIR WITH FAUX LEATHER UPHOLSTERED SEAT
- 4 -
STEP
2
Attach front legs (C-L) and (C-R) to the seat frame. Use bolts (2), washers (4) and (5) .Tighten with Allen Key (6).
Place front stretcher (E), side stretchers (D-L) and (D-R) between front and back legs, use the screw driver to
tighten the screws (7) as shown below.
Note: DO NOT tighten any of the bolts, until Place front stretcher (E), side stretchers (D-L) and (D-R) between
front and back legs the chair is assembled, then tighten the bolts and the screws.