Eaton S611 Manual

Installation Leaet IL03901007E Effective June 2011
S611 User Interface Remote Mounting
Installation Leaflet
Disconnect power in accordance with federal, state, and local codes and remove the S611 from the enclo-
sure or mounting panel.
NOTE: Servicing the S611 while installed in an enclosure or mounted vertically on a panel is not recom-
mended.
Place the unit on a clean work surface.
Cover Removal
1. Disconnect all control wiring and tie wraps securing any wiring to the cover assembly.
2. Remove cover screws with nuts. 6 each on Frames A – D, 4 each on Frames E - F.
NOTE: Cover screw nuts are prevented from rotating but are not retained in place by the pole
supports. Do not allow hardware to fall into the soft starter.
3. Lift top of cover approximately 6” to gain access to the BYPASS VOLTAGE contactor
connector mounted on the Printed Circuit Board (PCB). See Figure 1.
4. Press locking tab on BYPASS VOLTAGE contactor connector and disconnect from the PCB.
5. Carefully rotate cover to rest onto work surface as shown. See Figure 2.
Figure 1 - Contactor Connector Figure 2 - Cover Position
Mounting The Remote Display
If necessary, remove the User Interface from the cover using a 30mm pilot device tool (E22CW recom-
mended).
1. Drill or punch two 30mm pilot holes on 1.75-inch centers a minimum of 1.60 inches (40.6 mm)
from every door gasket (see Figure 3).
2. Insert remote display through the door and add two gaskets provided behind the door
(see Figure 4).

Installation Leaet IL03901007E
Effective June 2011
S611 Soft Starters
Eaton Corporation
Electrical Sector
1111 Superior Ave.
Cleveland, OH 44114
United States
877-ETN-CARE (877-386-2273)
Eaton.com
© 2008 Eaton Corporation
All Rights Reserved
Publication No. IL03901007E
June 2011 Rev.001
PowerChain Management is a registered
trademark of Eaton Corporation.
All other trademarks are property of their
respective owners.
Figure 3 - Pilot Device Holes - Inch[mm]
Minimum to all
gaskets ordoor
mounteddevices
1.60
[40.6]
1.75
[44.5]
Gaskets
E22CW
Tighten
Figure 4 - Door Cut Away For Clarity
3. Orient strain relief bracket with respect to your chosen cable routing.
4. Add two jam nuts provided and tighten 30mm pilot device tool until the strain relief bracket is
flush with the enclosure door, tighten an additional ½ of a turn.
Connecting the Remote Display
1. Route cable from User Interface to PCB (see Figures 5 & 6).
2. Secure cable to the strain relief bracket using any suitable tie wrap.
3. Reinstall cover assembly.
Figure 5 - Interconnecting Cable - PCB Figure 6 - Interconnecting Cable - User Interface
Cover Reinstallation
1. As the cover is placed onto the supports, carefully guide wiring into place.
2. Ensure that the BYPASS VOLTAGE contactor connector is properly connected prior to installing
the cover screws.
3. Install and torque all cover assembly screws to 22 – 27 lb-in.
4. Reinstall control wiring.