Eaton TSE80 User manual

Planning the installation
TSE80 requires a minimum mounting depth of
22mm from the front wall surface plus room for
cable/s. Power is supplied by Power Over Ethernet
(PoE). PoE must meet the IEEE 802.3af standard.
TSE80 connects to the local network via a hard
wired Ethernet connection.
Installation
TSE80 has been designed to mount to a US NEMA
2 gang back box (Ref: Eaton TSE80 Back Box).
Installing the mounting frame
TSE80 includes a mounting frame that MUST be
used for this installation.
Using the included screws mount the mounting
bracket onto the back box and verify that the
components are level before tightening the captive
screws on the TSE80.
Mounting height
The recommend
mounting height
for the TSE80 is
145 cm -165 cm
above the nished
oor to the center
of the unit.
TSE80 - Colour Touchscreen
Installation guide
Overview
Mounting the TSE80
Align the mounting
frame hooks with
the TSE80 mounting
slots and gently pull
the TSE80 unit down
the mounting bracket.
Make sure the mounting
hooks are properly
engaged.
Tighten the 2 captive screws
to secure the TSE80 to the
mounting bracket
Back Box
TSE80
Mounting Bracket
PoE and Data Connection (RJ45)

Power connection
TSE80 is designed to be powered over the Ethernet
connection (PoE).
PoE Connection
PoE connection requires IEEE 802.3af standard. Utilize a
network switch or PoE injector that meets this standard.
Connect the TSE80 using a standard CAT5E or CAT6
Ethernet cable from the network switch to the LAN/PoE
jack on the back of the TSE80.
Removing the TSE80
Loosen the 2 captive screws on the underside of the
TSE80. Lift the unit upwards off the mounting frame
hooks and then pull the unit away from the mounting
frame to disengage.
Specications
Dimensions: 223.5mm w (8.8”) x 148.3mm h (5.84”)
Mounting depth: 22mm (0.86”)
Display: 8” (203.2mm Diagonal))
Resolution: 1280 x 800
Network: 10/100/1000 Ethernet
Connections: LAN/PoE RJ45
Power Requirements: PoE - IEEE 802.3af,
13W maximum draw (@48 V 270 mA max)
Document: TSE80 9850-000671-02
Eaton - Lighting Systems
Usk House, Lakeside, Llantarnam Park, Cwmbran, NP44 3HD, UK
T: [phone] F: [phone]
E: [email protected] EatonLightingSystems.com
E&OE. Changes to the products, to the information contained in this
document, and to prices are reserved; so are errors and omissions. © Eaton
Loosen the 2 captive screws
before lifting off the unit
Connecting Ethernet
When not utilizing a PoE switch, it is recommended
that you connect the TSE80 to a network switch via
a PoE injector.
Utilizing a standard CAT5E or CAT6 network Ethernet
cable connect to the LAN/PoE jack.