Eazyzap CT870-A User manual

Model:
CT870-A
Glue Board
Fly Killer
Instruction manual
CT870-A_A5_v2_20220325.indb 1CT870-A_A5_v2_20220325.indb 1 2022/3/25 11:352022/3/25 11:35

2
EN Telephone Helpline: 1300225960
Safety Instructions
• A service agent/qualified
technician should carry out
installation and any repairs if
required. Do not remove any
components on this product.
• Consult Local and National
Standards to comply with the
following:
- Health and Safety at Work
Legislation
- Fire Precautions
- Wiring Regulations
- Building Regulations
• Always switch off and
disconnect the power supply to
the appliance before cleaning.
• Install the appliance out of
the reach of children.
• Never insert hands or other
objects into the appliance
while it is connected to the
power supply.
• Install the appliance at least
1 metre away from food
preparation areas.
• Never use near flammable
objects.
• Keep all packaging away
from children. Dispose of
the packaging in accordance
to the regulations of local
authorities.
• If the power cord is
damaged, it must be
replaced by an EAZYZAP
agent or a recommended
qualified technician in order
to avoid a hazard.
• EAZYZAP recommend that
this appliance should be
periodically tested (at least
annually) by a Competent
Person. Testing should include,
but not be limited to: Visual
Inspection, Polarity Test,
Earth Continuity, Insulation
Continuity and Functional
Testing.
• This appliance is not
intended for use by persons
(including children) with
reduced physical, sensory
or mental capabilities, or
lack of experience and
knowledge, unless they have
been given supervision or
instruction concerning use
of the appliance by a person
responsible for their safety.
• Children should be
supervised to ensure that
they do not play with the
appliance.
• For INDOOR use only.
CT870-A_A5_v2_20220325.indb 2CT870-A_A5_v2_20220325.indb 2 2022/3/25 11:352022/3/25 11:35

3
EN
Telephone Helpline: 1300225960
• The appliance is not to be
used in locations where
flammable vapour or
explosive dust is likely to
exist.
• Do not use in barns , stables
and similar locations.
Introduction
Please take a few moments to carefully read
through this manual. Correct maintenance and
operation of this machine will provide the best
possible performance from your EAZYZAP product.
Pack Contents
The following is included:
• EAZYZAP Glue board fly killer
• Detachable power cord
• Instruction manual
EAZYZAP prides itself on quality and service,
ensuring that at the time of unpacking the contents
are supplied fully functional and free of damage.
Should you find any damage as a result of transit,
please contact your EAZYZAP dealer immediately.
Installation
1. Remove all packaging and protective film from
the appliance.
2. For best results, locate the appliance in the
darkest part of the room, but at least 1 metre
away from food preparation areas.
Note: Close proximity to other light sources
such as sky lights and windows will reduce
the effectiveness of the appliance.
Prepare the mounting fixings (not supplied)
before installation. If in doubt seek
professional advice or assistance.
3. Upon necessity you can install the appliance
onto the wall as instructed below.
1
150 mm
• Drill 2 holes on the wall. Ensure there is no
electric/water pipe beneath the holes.
• Insert wall plugs and screws into the holes
consecutively (Fig. 1).
2
• Hang the appliance on the screws and ensure
it rests in place (Fig. 2).
CT870-A_A5_v2_20220325.indb 3CT870-A_A5_v2_20220325.indb 3 2022/3/25 11:362022/3/25 11:36

4
EN Telephone Helpline: 1300225960
Operation
WARNING: Under no
circumstances should hands
be placed anywhere near
the appliance when it is in
operation.
The appliance uses the specified wavelength of
black light tube to attract insects. Then the insects
are drawn towards glue board and can’t escape the
strength of the glue.
The appliance is highly efficient and harmless to
humans and pets. To use the appliance:
1. Connect the power cord to the appliance then
to the mains power.
2. The light will come on and ready for use.
Cleaning, Care &
Maintenance
Always switch off the power
and disconnect the appliance
from the power supply before
cleaning and maintenance.
• DO NOT immerse the appliance in water. Wipe
the safety guard and external casing with a
damp cloth.
Changing the glue board and light
WARNING: Always turn Off
the appliance and disconnect
from the power supply before
changing the glue board or
light.
Replace the glue board
regularly (on a monthly
basis). To change the
glue board, simply pull it
out (Fig. 3). Replace with
a new one.
To change the light:
1. Remove the 2 screws
on the metal support
that is fixing the light
tube.
2. Remove the metal
support.
3. Twist the light tube
anti-clockwise from
its socket.
4. Insert the new light
and twist clockwise
until tight.
5. Re-put the metal
support in place.
3
Glue board
Metal support
Troubleshooting
A qualified technician must carry out repairs if required.
Fault Probable Cause Solution
The appliance is
not working
Unit is not switched on Check the unit is plugged in correctly
Plug or lead is damaged Replace plug or lead
Mains power supply fault Check mains power supply
Tube has expired Refer to the ‘Changing the glue board and light’
section
Tube is faulty or has not been fitted
correctly
CT870-A_A5_v2_20220325.indb 4CT870-A_A5_v2_20220325.indb 4 2022/3/25 11:362022/3/25 11:36

5
EN
Telephone Helpline: 1300225960
Technical Specifications
Model Voltage Power Dimensions
h x w x d (mm) Weight Lamp type
CT870-A 220-240V~
50/60Hz
13W 325 x 235.8 x 122 0.85kg E27 13W UVA energy
saving lamp
Electrical Wiring
The plug is to be connected to a suitable mains socket.
This appliance is wired as follows:
• Live wire (coloured brown) to terminal marked L
• Neutral wire (coloured blue) to terminal marked N
• Earth wire (coloured green/yellow) to terminal marked E
This appliance must be earthed.
If in doubt consult a qualified electrician.
Electrical isolation points must be kept clear of any obstructions. In the event of any emergency
disconnection being required they must be readily accessible.
Compliance
The product must not be disposed of as household waste. To help prevent possible harm to human
health and/or the environment, the product must be disposed of in an approved and environmentally safe
recycling process. For further information on how to dispose of this product correctly, contact the product
supplier, or the local authority responsible for waste disposal in your area.
EAZYZAP parts have undergone strict product testing in order to comply with
regulatory standards and specifications set by international, independent, and
federal authorities.
EAZYZAP products have been approved to carry the following symbol:
All rights reserved. No part of these instructions may be produced or transmitted in any form or by any means, electronic,
mechanical, photocopying, recording or otherwise, without the prior written permission of EAZYZAP.
Every effort is made to ensure all details are correct at the time of going to press, however, EAZYZAP reserve the right to
change specifications without notice.
CT870-A_A5_v2_20220325.indb 5CT870-A_A5_v2_20220325.indb 5 2022/3/25 11:362022/3/25 11:36

DECLARATION OF CONFORMITY
• Conformiteitsverklaring • Déclaration de conformité • Konformitätserklärung • Dichiarazione di conformità •
• Declaración de conformidad • Declaração de conformidade
Equipment Type • Uitrustingstype • Type d'équipement • Gerätetyp
• Tipo di apparecchiatura • Tipo de equipo • Tipo de equipamento
Model • Modèle • Modell • Modello
• Modelo • Malli
Eazyzap Glue Trap
CT870 (& -E -A)
Application of Territory Legislation &
Council Directives(s)
Toepassing van Europese Richtlijn(en) •
Application de la/des directive(s) du
Conseil • Anwendbare EU-Richtlinie(n)
• Applicazione delle Direttive
• Aplicación de la(s) directiva(s) del
consejo • Aplicação de directiva(s) do
Conselho
Low Voltage Directive (LVD) - 2014/35/EU
Electrical Equipment (Safety) Regulations 2016
EN 60335-1:2012 +A11:2014 +A13:2017 +A1:2019
+A14:2019 +A2:2019
EN 60335-2-59:2003 +A1:2006 +A2:2009 +A11:2018
EN 62233:2008
Electro-Magnetic Compatibility (EMC) Directive
2014/30/EU - recast of 2004/108/EC
Electromagnetic Compatibility Regulations 2016
(S.I. 2016/1091)
EN55014-1:2017
EN55014-2:2015
EN IEC 61000-3-2: 2019
EN 61000-3-3: 2013 +A1:2019
Restriction of Hazardous Substances Directive
(RoHS) 2015/863 amending Annex II to Directive
2011/65/EU
Restriction of the Use of Certain Hazardous
Substances in Electrical and Electronic Equipment
Regulations 2012 (S.I. 2012/3032)
Electrical Safety
IEC 60335-1:2010 +A1:2013 +A2:2016
IEC 60335-2-59:2002 +A1:2006 +A2:2009
Electromagnetic Compatibility
EN55014-1:2017
EN55014-2:2015
EN IEC 61000-3-2: 2019
EN 61000-3-3: 2013 +A1:2019
Producer Name • Naam fabrikant • Nom du producteur • Name des Herstellers
• Nome del produttore • Nombre del fabricante • Nome do fabricante
Eazyzap
I, the undersigned, hereby declare that the equipment specified above conforms to the above Territory Legislation, Directive(s) and
Standard(s).
Ik, de ondergetekende, verklaar hierbij dat de hierboven gespecificeerde uitrusting goedgekeurd is volgens de bovenstaande Richtlijn(en) en
Standaard(en).
Je soussigné, confirme la conformité de l'équipement cité dans la présente à la / aux Directive(s) et Norme(s) ci-dessus
Ich, der/die Unterzeichnende, erkläre hiermit, dass das oben angegebene Gerät der/den oben angeführten Richtlinie(n) und Norm(en) entspricht.
Il sottoscritto dichiara che l'apparecchiatura di sopra specificata è conforme alle Direttive e agli Standard sopra riportati.
El abajo firmante declara por la presente que el equipo arriba especificado está en conformidad con la(s) directiva(s) y estándar(es) arriba
mencionadas.
Eu, o abaixo-assinado, declaro que o equipamento anteriormente especificado está em conformidade com a(s) anterior(es) Directiva(s) e
Norma(s)
Date • Data • Date • Datum • Data •
Fecha • Data
29th April 2021
Signature • Handtekening •
Signature • Unterschrift Firma •
Firma • Assinatura
Full Name • Volledige naam • Nom
et prénom • Vollständiger Name •
Nome completo • Nombre completo
• Nome por extenso
Ashley Hooper
Eoghan Donnellan
Josie Holt
Position • Functie • Fonction •
Position • Qualifica • Posición •
Função
Technical & Quality
Manager
Commercial Manager/
Importer
Commercial Manager/ Responsible
Supplier
Producer Address • Adres fabrikant •
Adresse du producteur • Anschrift
des Herstellers • Indirizzo del
produttore • Dirección del fabricante
• Morada do fabricante
Fourth Way,
Avonmouth,
Bristol,
BS11 8TB
United Kingdom
42 North Point
Business Park
New Mallow Road
Cork
Ireland
15 Bagdally Road,
Campbelltown
NSW 2560
DocuSign Envelope ID: 82CF60EC-07ED-4BB9-9B0D-D025707A0398
Unit 9003,
Blarney Business Park,
Blarney,
Co. Cork
Ireland
Eazyzap Glue Board Fly Killer
CT870-A_A5_v2_20220325.indb 6CT870-A_A5_v2_20220325.indb 6 2022/3/25 11:362022/3/25 11:36

CT870-A_A5_v2_20220325.indb 7CT870-A_A5_v2_20220325.indb 7 2022/3/25 11:362022/3/25 11:36

CT870-A_A5_v2_20220325
CT870-A_A5_v2_20220325.indb 8CT870-A_A5_v2_20220325.indb 8 2022/3/25 11:362022/3/25 11:36