ECR 4 Kids ELR Series User manual

Use a Phillips
Screwdriver
Use a Phillips
Screwdriver
Legs (4) Phillips Screws (8)
Split Washers & Machine Screws (12)
C1 C2
Parts List
A
BEFORE ASSEMBLING, MAKE SURE YOU HAVE ALL THE PARTS
B
C
Batch ID Sticker
located on underside
1Install Legs onto Table Frame
Use the Hex Tool
to adjust leg height
Resin Tables
Model #’s : ELR-14405—14407
Adult Assembly Required.
Two adults recommended.
- Contains small parts, sharp points and edges.
- Do not stand, sit, kneel, climb, lean or pull on
unit for support.
- Never leave children unattended.
- Do not place unit near high heat or moisture.
- Adult supervision recommended.
WARNING:
San Diego, CA 92110 USA
www.ecr4kids.com
See Next Page
TOOLS INCLUDED
Hex Tool (1)
TOOLS NEEDED
Phillips Screwdriver
Install each Leg (A) onto the Table Top with three Machine Screws (C2)
along with the Split Washers (C1) using a Phillips screwdriver.
Do not use power tools.

2
Install the Phillips Screws
Adjust the Leg Height
3
Care and Cleaning
Clean unit with a damp cloth or sponge
using warm water and mild soap. Wipe dry.
Do not place near heat, moisture or
vaporizer which may cause panels to warp
and peel.
Check for loose or worn parts periodically
and tighten or replace as necessary.
©2014 ECR4KIDS, LP Version: ELR-14405,14406,14407_BT_2014.08.26
Record the manufacture date here.
Information is located on the Batch ID
sticker and on the shipping carton.
Save this sheet in an accessible place.
Model Number: ELR-14405, 14406, 14407
(circle one)
Factory Code: BT
Manufacture Date:
Batch ID Number:
(Located on Part A)
We appreciate your purchase of the Resin Table.
ECR4KIDS has made every effort to supply a quality product that with proper
use and care, will provide many years of trouble-free use.
Warranty: Visit our website for product specific warranty information at:
www.ecr4kids.com
If you experience any difficulties with this product, please email us at
[email protected] or call toll-free at (855) ECR-4KIDS
(Monday - Friday, 7:00am - 4:00pm Pacific Standard Time)
Please do not return to place of purchase as ECR4KIDS will
replace defective part(s) and/or product.
Complete the installation of each Leg (A) onto the Table Top with two
Phillips Screws (C2) using a Phillips screwdriver.
Do not use power tools.
Loosen the Lower Leg Extension Hex Set Screw to adjust the leg to the desired height,
align the holes and secure the set screw.
Tip: If the table has a wobble or is on a
uneven surface. Rotate the small black
glide adjustment to remove the wobble.
Legs adjust from
13.5” to 22.5”