ECR 4 Kids ELR-0421-A User manual

J
Upper Shelf (1)
Lower Shelf (1)
B
C
D
E
F
Use the Hex Tool.
Batch ID
located underneath.
Top Panel (1)
Left & Right
Side Panels (1/1)
Parts List
A
BEFORE ASSEMBLING, MAKE SURE YOU HAVE ALL THE PARTS
Phillips Screws & Casters (16/4)
Cam Posts & Cam Locks (10/10)
Bottom Shelf (1)
Dividers (5)
Back Panels (3)
Hex Screws (26)
Use a Phillips Screwdriver.
Use a Phillips Screwdriver.
G
H
I
Children climbing on furniture can lead to
death or serious injury due to tipping.
Secure unit to wall using appropriate
hardware.
J1 J2
I1 I2
A1 A2
Adult Assembly Required.
Two adults recommended.
- Contains small parts, sharp points and edges.
- Do not stand, sit, kneel, climb, lean or pull on unit
for support.
- Never leave children unattended.
- Do not place unit near high heat or moisture.
- Adult supervision recommended.
WARNING:
TOOLS INCLUDED
Hex Tool (1)
TOOLS NEEDED
Phillips Screwdriver
8 Compartment
Storage Cabinet
Model# ELR-0421-A
San Diego, CA 92110 USA
www.ecr4kids.com

4
Install Lower Dividers to Bottom Shelf
2
Install Upper Dividers to Upper Shelf
1
Install the Casters onto Bottom Shelf
3
Install Middle Divider to Lower Shelf
Install the four Casters (I2) into the pre-drilled holes on the underside of the Bottom Shelf (D),
with four Phillips Screws (I1) per caster, using a Phillips screwdriver.
Install one Divider (G) on to the Lower Shelf (D) with two Hex Screws (H) using the Hex Tool.
Note: The grooves on the Lower Shelf are away from the ground.
Place two Cam Locks (I2) into the recessed holes on each Divider (G), with the arrow facing
the closest edge.
Install two Dividers (G) on to the Upper Shelf (C) with four Hex Screws (H) using the Hex Tool.
Note: The grooves on the Upper Shelf are away from the ground.
Place two Cam Locks (I2) into the recessed holes on each Divider (G), with the arrow facing the
closest edge.
Install two Dividers (G) on to the Bottom Shelf (E) with four Hex Screws (H) using the Hex Tool.
Note: The groove on the Bottom Shelf is away from the ground.
Place two Cam Locks (I2) into the recessed holes on each Divider (G), with the arrow facing the
closest edge.
See Next Page
Batch ID Sticker

7
8
Connect Upper Shelf to Middle Divider
Install Right Side Panel
5Connect Lower Shelf to Lower Dividers
6Connect Top Panel to Upper Dividers
Install the Right Side Panel (A2) on to the Top Panel (B), Upper & Lower Shelves (C, D) &
Bottom Shelf (E) with eight Hex Screws (H) using the Hex Tool.
Install four Cam Posts (I1) into the threaded plastic inserts on the underside of Lower Shelf (D)
with a Phillips screwdriver.
Reminder: Do not overtighten, as the plastic threads can be stripped.
Insert the Lower Shelf (D) Cam Posts into the holes on the top edge of the Lower Dividers (G).
Turn the Cam Locks (I2) clockwise with a Phillips screwdriver to lock the Lower Dividers (G)
onto the posts.
Install two Cam Posts (I1) into the threaded plastic inserts on the underside of Upper Shelf (C)
with a Phillips screwdriver.
Reminder: Do not overtighten, as the plastic threads can be stripped.
Insert the Upper Shelf (C) Cam Posts into the holes on the top edge of the Middle Divider (G).
Turn the Cam Locks (I2) clockwise with a Phillips screwdriver to lock the Middle Divider (G)
onto the posts.
See Next Page
Install four Cam Posts (I1) into the threaded plastic inserts on the underside of Top Panel (B)
with a Phillips screwdriver.
Reminder: Do not overtighten, as the plastic threads can be stripped.
Insert the Top Panel (B) Cam Posts into the holes on the top edge of the Upper Dividers (G).
Turn the Cam Locks (I2) clockwise with a Phillips screwdriver to lock the Upper Dividers (G)
onto the posts.
Note: The groove on the Top Panel is away from the ground.

10
9
Insert the Back Panels
Install Left Side Panel
C
a
r
e
f
u
l
l
y
R
o
t
a
t
e
U
p
r
i
g
h
t
Install the Left Side Panel (A1) on to the Top Panel (B), Upper & Lower Shelves (C, D) &
Bottom Shelf (E) with eight Hex Screws (G) using the Hex Tool.
Two Adults Recommended: Carefully rotate unit upright.
Slide the Back Panels (F) into the grooves on the Top Panel (B), Upper & Lower Shelves (C, D)
& Bottom Shelf (E) as shown, until fully seated into the groove on the inside of the Right Side
Panel (A2).
Tip: If the Back Panels do not slide in easily, wiggle the panels while pushing into place.
©2013 ECR4KIDS, LP Version: ELR-0421-A_EP_2013.04.01
Care and Cleaning
Clean wood with a damp cloth or sponge
using warm water and mild soap. Wipe dry.
Do not place near heat, moisture or
vaporizer which may cause wood to warp
and peel.
Check for loose or worn parts periodically
and tighten or replace as necessary.
Record the manufacture date here.
Information is located on the Batch ID
sticker and on the shipping carton.
Save this sheet in an accessible place.
Model Number: ELR-0421-A
Factory Code: EP
Manufacture Date:
Batch ID Number:
(Located on Part E)
We appreciate your purchase of the 8 Compartment Storage Cabinet.
ECR4KIDS has made every effort to supply a quality product that with proper
use and care, will provide many years of trouble-free use.
Warranty: Visit our website for product specific warranty information at:
www.ecr4kids.com
If you experience any difficulties with this product, please email us at
[email protected] or call toll-free at (855) ECR-4KIDS
(Monday - Friday, 7:00am - 4:00pm Pacific Standard Time)
Please do not return to place of purchase as ECR4KIDS will
replace defective part(s) and/or product.
To prevent a tip-over tragedy:
Buy and install low-cost anchoring devices that can prevent TVs,
dressers, bookcases and other furniture from tipping. For more
information please visit www.ecr4kids.com/resources